AMX NXD-430-WH Specifications download pdf (Page 46)

Configuring Communication

NXD-430/435/435P 4.3” Wall/Flush Mount Touch Panels

Step 3: Configure an Ethernet Connection Type

Before commencing, verify that the NetLinx Master is using the latest available version of its firmware.

Before beginning:

Verify that the panel has been configured to communicate through an Ethernet cable connected

from the panel to a valid Ethernet Hub.

Verify that the NetLinx Master is receiving power and is communicating via an Ethernet connection

with the PC running NetLinx Studio.

Verify that the green Ethernet LED on the rear Ethernet port on the Master is illuminated, indicating

a proper connection.

Verify that the yellow LED on the rear Ethernet port on the Master is blinking, indicating

communication with the device.

1. After the panel powers-up, press and hold the Front Setup Access button for 6 seconds to proceed to the

Status page.

2. Select Protected Setup > System Settings and click the Master tab (FIG. 32).

Master Tab - Virtual Master Communication Over Ethernet

Before beginning, verify that the panel has been configured to communicate through an Ethernet cable

connected from the panel to a valid Ethernet Hub.

1. In NetLinx Studio, select Settings > Master Communication Settings to open the Master

Communication Settings dialog (FIG. 33).

When using Ethernet as the selected communication method, the NetLinx Master

must first be set up with either a Static IP or DHCP Address obtained from either

NetLinx Studio or your System Administrator.

FIG. 32 System Settings Page - Master Tab

Obtained from

NetLinx Master

When configuring the panel to communicate with a Virtual Master (on your PC) via

Ethernet, the Master IP/URL field must be configured to match the IP Address of the

PC. Make sure to use the Virtual System value assigned to the Virtual Master within

NetLinx Studio.

1 ... 45 46 47 ... 146

No comments

AMX NXD-430-WH Specifications Page 46