AMX NXD-430-WH Specifications download pdf (Page 33)

Panel Calibration

NXD-430/435/435P 4.3” Wall/Flush Mount Touch Panels

Panel Calibration

Overview

This section outlines the steps for calibrating an NXD-430 or NXD-435 touch panel.

Modero panels are set up in the factory with specific demo touch panel pages. The first splash screen that

appears indicates the panel is receiving power, beginning to load firmware, and preparing to display the default

touch panel pages. When the panel is ready, the AMX Splash Screen is replaced by the Initial Panel Page.

Calibrating the Modero Panel

1. Press and hold the Front Setup Access button (FIG. 16) for 9 seconds to pass over the Setup page and

access the Calibrate page (FIG. 17).

2. Press the crosshairs (on the Calibrate page) to set the calibration points on the LCD (FIG. 17).

Calibrating the panel before its initial use and after completing a firmware download is

highly recommended.

FIG. 16 NXD-430 Modero Wall/Flush Mount Touch Panel

Front Setup Access button

1 ... 32 33 34 ... 146

No comments

AMX NXD-430-WH Specifications Page 33