AMX NXD-430-WH Specifications download pdf (Page 28)

Installation

NXD-430/435/435P 4.3” Wall/Flush Mount Touch Panels

4. Disconnect the capacitive touch connector (B in FIG. 12) from the 10-pin male plug on the faceplate.

5. Thread the incoming Ethernet and USB wiring from their terminal sources through the surface opening.

Leave enough slack in the wiring to accommodate any re-positioning of the panel.

6. Insert all connectors into their corresponding locations along the left side of the un-powered touch panel.

The USB connectors can be from either a USB extension cable or a wireless USB RF transmitter.

7. Test the incoming wiring by connecting the panel connections to their terminal locations.

Verify that the panel is receiving power and functioning properly before finalizing the installation.

8. Carefully slide the main unit into the cutout, making sure that the locking tabs lie flush against the back

box.

9. Insert and secure three #4 Mounting Screws (not included) into the corresponding holes located along the

sides of the device, using a grounded Phillips-head screwdriver, until the unit is secure and flush against

the wall (FIG. 12).

10. Reconnect the capacitive touch connector to the 10-pin plug on the faceplate.

11. Place the faceplate back onto the device.

FIG. 12 Wall Mount panel installation configuration for flat surfaces

B - 10-pin capacitive

Flat installation surface

A - Faceplate

Locking Tabs

touch connector

Ethernet and USB

Connectors

Do not disconnect the connectors from the touch panel.

The unit must be installed with the necessary connectors before being inserted into

the solid surface.

1 ... 27 28 29 ... 146

No comments

AMX NXD-430-WH Specifications Page 28