AMX NXD-430-WH Specifications download pdf (Page 27)

Installation

NXD-430/435/435P 4.3” Wall/Flush Mount Touch Panels

10. Reconnect the capacitive touch connector to the 10-pin male plug on the faceplate.

11. Place the faceplate back onto the main device.

Installing the NXD-430 and NXD-435 into a Flat Surface using #4 screws

Three #4 mounting screws (not included) are secured through circular holes located at the left and right sides

of the touch panel.

Refer to SP-2261-02 for detailed installation dimensions (reproduced in FIG. 11).

Cutting out the surface slightly smaller than what is outlined in the installation drawings in order to

make any necessary cutout adjustments, is highly recommended.

1. Prepare the area by removing any screws or nails from the surface before beginning the cutout process.

2. Cut out the surface for the touch panel using the dimensions shown in FIG. 11.

3. Remove the faceplate (A in FIG. 12) from the touch panel by gripping the faceplate and carefully pulling

up and out with gentle force.

The maximum recommended torque to screw in the locking tabs on the back box is 5

IN-LB [56 N-CM]. Applying excessive torque while tightening the locking tab screws,

such as with powered screwdrivers, can strip out the tabs or damage the back box.

Use either a manual screwdriver or a variable torque motorized screwdriver at its

lowest setting, and stop as soon as the panel is snugly secured.

If needing to uninstall the back box, make sure that the heads to the locking tab

screws do not touch the back of the circuit board. Use either a manual screwdriver or

a variable torque motorized screwdriver at its lowest setting, and stop as soon as the

locking tabs have moved into the slots on the sides of the back box.

The most important thing to remember when mounting the touch panel is that the

back box must be installed flush against the mounting surface.

FIG. 11 NXD-430 Wall Mount panel dimensions

1 ... 26 27 28 ... 146

No comments

AMX NXD-430-WH Specifications Page 27