AMX RADIA LIGHTING CONTROL ENCLOSURE WORKSHEET GUIDE Specifications Page 58

  • Download
  • Add to my manuals
  • Print
  • Page
    / 80
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 57
8. Advanced Output Methods
Rain Bird
®
ET Manager Series - Installation and Operation Manual 58
The processes of mounting, grounding, and connecting
the power source are the same as for the Enable Output
Method. Complete the following steps to connect the
ET and Weather Interrupt circuit:
1. You MUST remove the jumper wire connecting
the “Jumperterminals.
2. Connect two wires from the ET pulse sensor
input from the sprinkler controller to the NOA
and A terminals on the ET Manager.
3. Route the sprinkler controller valve common
through the “Com” and “B” terminals on the ET
Manager.
ET Manager Programming using ET Pulse
with Weather Interrupt
There are several settings in your ET Manager that must
be set correctly for ET Pulse with Weather Interrupt.
The settings are different for each sprinkler controller.
Check the input requirements of the controller before
programming your ET Manager. The following settings
need to be made:
1. The Output Method must be set to ET Pulse
with Interrupt.
Main Menu
Settings System
Output Method ET Pulse with Interrupt
Wiring ET Pulse with Weather Interrupt
Figure 17. ET Manager Terminal Connections ET Pulse with Weather Interrupt
Page view 57
1 ... 57 58 59 ... 80

Comments to this Manuals

No comments