AMX RADIA LIGHTING CONTROL ENCLOSURE WORKSHEET GUIDE Specifications Page 18
- Page / 80
- Table of contents
- TROUBLESHOOTING
- BOOKMARKS
Rated. / 5. Based on customer reviews
3. Programming
Rain Bird
®
ET Manager Series - Installation and Operation Manual 18
Weather Region
Main Menu Settings System Data Source
Weather Region
The weather region number represents a weather sta-
tion assigned by the WRSP. The weather region you set
should correspond to a weather station that closely rep-
resents the location of the ET Manager. To obtain your
weather region number, contact your WRSP, the Rain
Bird Distributor, your installation contractor, or go to
www.rainbird.com/etmanager.
To set the weather region, navigate the menus to
Weather Region, press
À to move the cursor location
to the number and use the
Œ or Õ to enter the weath-
er region number.
Rain Source
Main Menu Settings System Data Source
Rain Source
The rain source may come from:
• Signal: Use the rain value in the weather sig-
nal from the selected weather region.
• Local (1mm per tip): Use an on-site tipping
bucket rain gauge connected to the Rain Tip-in
terminal that measures rain with a 1mm per tip
signal (ETM-RG Tipping Rain Gauge).
• Local (0.01” per tip): Use an on-site tipping
bucket rain gauge connected to the Rain Tip-in
terminal that measures rain with a 0.01” per tip
signal.
• Rain Region: Like the weather region number,
a rain region number represents an area where
customers share data. Within an area, one on-
site tipping bucket rain gauge is used to share
localized rain data among ET Manager cus-
tomers, allowing for a more accurate represen-
tation of local rain. Your WRSP broadcasts rain
region data.
To set the rain source, navigate the menus to Rain
Source, press
À to enter into the Rain Source screen.
Press
À once more to change the • to the cursor, .
Use the
Œ or Õ to select the rain source.
If the rain region is selected, press
À to move the cur-
sor location to the rain region number and use the
Œ
or Õ to enter the rain region number.
Elevation
Main Menu Settings System Data Source
Elevation
Elevation above sea level is used when calculating ET.
To enter a close estimation of your elevation, navigate
the menus to Elevation, press
À to move the cursor
location to the elevation, and use the
Œ or Õ to set
the elevation.
Signal Provider Code
Main Menu Settings System Data Source
Signal Provider Code
Your ET Manager must be programmed to receive
information from your specific WRSP. A Signal Provider
Code is unique for your WRSP and is necessary for your
ET Manager to receive a weather signal. The code con-
sists of 10 different numbers and these 10 numbers are
labeled A-J. To obtain this code, contact your WRSP, the
Rain Bird Distributor, your installation contractor, or go
to www.rainbird.com/etmanager.
Navigate the Menus to
the Signal Provider
Code and press
À to
enter into the Signal
Provider Code screen.
Press
Õ to move the
cursor to “Yes” and press
À. Use the Œ, Õ and À
buttons to set the codes for A through J.
- ET Manager Series 1
- Table of Contents 2
- 1. Introduction 3
- The Weather Reach Water 4
- Management System 4
- Getting to Know your 5
- Rain Bird ET Manager 5
- LCD Contrast 6
- Attention Indicator Light 6
- Specifications 7
- Resource CD Included with 8
- Getting Ready to use 8
- Your ET Manager 8
- Mounting 10
- Wire Connections 11
- 4” insulation off the ends 12
- Wiring Diagrams 13
- Optional Rain Gauge 13
- 2. Installation 14
- Optional External Antenna 15
- Install Battery 16
- 3. Programming 17
- Weather Region 18
- Rain Source 18
- Elevation 18
- Signal Provider Code 18
- 2. Output Method 19
- Output Method 19
- 3. Site Specific Settings 19
- Irrigation Control 19
- Weather Interrupt 23
- System Options 24
- Programming the Sprinkler 25
- Controller 25
- Cycle Start Times 26
- Station Run Times 26
- 4. System Check 27
- Override 28
- Weather Signal Test 28
- Valve Control Test 29
- Water Window Settings 29
- Initial Moisture Levels 29
- 5. Routine Operation 30
- Irrigation Status 31
- 5. Routine Operations 32
- Information Log 33
- Status Messages 34
- Attention Messages 35
- No Paging Signal 37
- Signal Accuracy 38
- No Historical ET Data 39
- Decoder Failure 39
- No Watering Detected 39
- Rain Tip Input Failure 39
- Set Signal Provider Code 40
- Window Overlaps Off Day 40
- 6. Determining 41
- Programmable Settings 41
- Rain Bird 42
- Landscape Conditions 43
- Plant Type 43
- Soil Type 43
- Root Depth 43
- ET Manager Settings 44
- Water Window 45
- Available Days 46
- Advanced Settings 46
- Effective Rain Settings 46
- ET Manager Scheduler 47
- 7. Troubleshooting 48
- Water Management 49
- Troubleshooting 49
- Group are too dry or too wet 50
- 8. Advanced Output Methods 53
- Wiring “A Then B” 54
- ET & Rain Pulse 55
- Wiring ET and Rain Pulse 56
- Using More than One Sprinkler 59
- 9. Appendices 60
- Precipitation Rate 65
- Station Run Time 65
- Master Valve Control 70
- Pump Control 72
- 10. Glossary 73
- The Intelligent Use of Water 80
© 2020, manymanuals.com. All rights reserved. | 0.043 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals