AMX RADIA LIGHTING CONTROL ENCLOSURE WORKSHEET GUIDE Specifications download pdf (Page 50)

7. Troubleshooting

Rain Bird

ET Manager Series - Installation and Operation Manual 50

Note: Adjust the run time using small intervals of time.

This will help determine what run time is optimal to

prevent dry or wet zones.

Most stations within the entire Valve

Group are too dry or too wet.

There are two possible causes of all the stations within

entire Valve Group being to dry or too wet:

• The Irrigation Amounts for A or B were not cor-

rectly programmed.

• A run time problem programmed in your

sprinkler controller.

If your Valve Group is overly dry, water the stations in

the Valve Group by following the steps outlined in “You

want your sprinkler system to water on the next

cycle” pg. .

Please follow these steps:

1. Check the run times on your sprinkler con-

troller. The dry or wet Valve Group can be

caused by too little or too much run time for

each station in the Valve Group.

2. Adjust the run time using small intervals of

time. This will help determine what run time is

optimal to prevent dry or wet stations.

3. If steps 1 and 2 do not fix this problem, you

should adjust the Irrigation Amounts in the ET

Manager.

4. Increase or decrease your Irrigation Amounts

for Valve Group A or B.

Main Menu

Settings Irrigation Control

Irrigation Amount & Adjust

Increasing the Irrigation Amount decreases the

frequency of watering and decreasing the

Irrigation Amount increases the frequency of

watering. You want to increase your Irrigation

Amount if you are experiencing a wet Valve Group

and you want to decrease your Irrigation Amount

if you have a dry Valve Group.

Refer to chapter 6, Determining Programmable

Settings, for more information to properly adjust the

Irrigation Amount values.

The site is watering every day.

There are three possible causes of why the site is water-

ing everyday:

• The Irrigation Amounts for A or B are pro-

grammed too low.

• The Automatic Window is not correctly pro-

grammed.

• The ET Manager was not properly installed.

1. The Irrigation Amounts for Valve Group A or B

could be too low. Refer to chapter 6,

Determining Programmable Settings, for more

information to properly adjust the Irrigation

Amount values.

Main Menu

Settings Irrigation Control

Irrigation Amount & Adjust

2. The Automatic Window setting may not be syn-

chronized to the time of day when watering is

scheduled to occur in the sprinkler controller. If

the watering cycle occurs outside the pro-

grammed Automatic Window, watering is not

detected and the Current Moisture Level(s) is

not adjusted. Refer to chapter 3, Programming,

for more information on programming the

Automatic Window.

Main Menu

Settings Irrigation Control

Water Window Automatic Window

3. Wiring is not properly installed. Follow the

Valve Control Test steps outlined in chapter 4,

System Check. If test fails, wiring is not proper-

ly installed.

1 ... 49 50 51 ... 80

Comments to this Manuals

No comments

AMX RADIA LIGHTING CONTROL ENCLOSURE WORKSHEET GUIDE Specifications Page 50

Comments to this Manuals