AMX RADIA LIGHTING CONTROL ENCLOSURE WORKSHEET GUIDE Specifications Page 51
- Page / 80
- Table of contents
- TROUBLESHOOTING
- BOOKMARKS
Rated. / 5. Based on customer reviews
7. Troubleshooting
Rain Bird
®
ET Manager Series - Installation and Operation Manual 51
You want your sprinkler system to water
on the next cycle.
There may be occasions when, in your judgment, the
sprinklers should water tonight or the next watering
cycle. When the Valve Group A or B Indicator Light is
green, then watering will be allowed during the next
scheduled cycle. If the Valve Group A or B Indicator
Light is red and you want to allow the next scheduled
cycle to come on, then adjust the Current Moisture
Level for Valve Group A and/or B to allow watering.
1. Determine which Valve Group A or B you want
to run. Remember the A and B Moisture Levels
are specific to types of plants (e.g. lawn and
shrubs).
2. Decrease the A or B Moisture Level to zero.
Main Menu
Irrigation Status
“A” or “B” Moisture Level
3. Once the level reaches zero the red Valve Group
Indicator Light will change to green and your
ET Manager will allow your sprinkler system to
water a complete cycle once the Automatic
Window is open.
Note: The Valve Group Indicator Light(s) will not turn
green if the Automatic Window is open, or if the current
day is a no water day. If either of these conditions is
occurring, the Home screen will notify you.
After a rainstorm my sprinkler system
resumes watering too soon.
Walk through each step below to prevent your sprinkler
system from watering too soon after a rainstorm.
1. The location of your optional rain gauge may
be poorly sited. Make certain there are no
obstacles blocking rain from entering the rain
gauge.
2. Check the Rain Source to verify the ET
Manager is programmed to the correct source,
specifically when using an optional rain gauge.
Main Menu
Settings System
Data Source Rain Source
3. The Maximum Hourly Rain setting may be lim-
iting the amount of rainfall applied to the
Moisture Levels. Change the Maximum Hourly
Rain to a higher amount to allow the ET
Manager to accept more rainfall in the
Moisture Levels for Valve Group A and B.
Main Menu
Settings Irrigation Control
Advanced Settings Effective Rain Settings
Max Hourly Rain
4. The Saturation Allowance for A or B may be too
low. Change the Saturation Allowance to a
higher amount to allow the ET Manager to
accept more rainfall in the Moisture Levels for
Valve Group A and B.
Main Menu
Settings Irrigation Control
Advanced Settings Effective Rain Settings
Saturation Allowance A or B
5. The weather signal rainfall value may not cor-
rectly represent rainfall at your site. Connect
an optional rain gauge, see chapter 2,
Installation.
After a rainstorm my sprinkler system
does not resume watering soon enough.
If your sprinkler system does not resume watering soon
enough after a rainstorm, follow these steps:
1. Check the Rain Source to verify the ET
Manager is programmed to the correct source,
specifically when using an optional rain gauge.
Main Menu
Settings System
Data Source Rain Source
- ET Manager Series 1
- Table of Contents 2
- 1. Introduction 3
- The Weather Reach Water 4
- Management System 4
- Getting to Know your 5
- Rain Bird ET Manager 5
- LCD Contrast 6
- Attention Indicator Light 6
- Specifications 7
- Resource CD Included with 8
- Getting Ready to use 8
- Your ET Manager 8
- Mounting 10
- Wire Connections 11
- 4” insulation off the ends 12
- Wiring Diagrams 13
- Optional Rain Gauge 13
- 2. Installation 14
- Optional External Antenna 15
- Install Battery 16
- 3. Programming 17
- Weather Region 18
- Rain Source 18
- Elevation 18
- Signal Provider Code 18
- 2. Output Method 19
- Output Method 19
- 3. Site Specific Settings 19
- Irrigation Control 19
- Weather Interrupt 23
- System Options 24
- Programming the Sprinkler 25
- Controller 25
- Cycle Start Times 26
- Station Run Times 26
- 4. System Check 27
- Override 28
- Weather Signal Test 28
- Valve Control Test 29
- Water Window Settings 29
- Initial Moisture Levels 29
- 5. Routine Operation 30
- Irrigation Status 31
- 5. Routine Operations 32
- Information Log 33
- Status Messages 34
- Attention Messages 35
- No Paging Signal 37
- Signal Accuracy 38
- No Historical ET Data 39
- Decoder Failure 39
- No Watering Detected 39
- Rain Tip Input Failure 39
- Set Signal Provider Code 40
- Window Overlaps Off Day 40
- 6. Determining 41
- Programmable Settings 41
- Rain Bird 42
- Landscape Conditions 43
- Plant Type 43
- Soil Type 43
- Root Depth 43
- ET Manager Settings 44
- Water Window 45
- Available Days 46
- Advanced Settings 46
- Effective Rain Settings 46
- ET Manager Scheduler 47
- 7. Troubleshooting 48
- Water Management 49
- Troubleshooting 49
- Group are too dry or too wet 50
- 8. Advanced Output Methods 53
- Wiring “A Then B” 54
- ET & Rain Pulse 55
- Wiring ET and Rain Pulse 56
- Using More than One Sprinkler 59
- 9. Appendices 60
- Precipitation Rate 65
- Station Run Time 65
- Master Valve Control 70
- Pump Control 72
- 10. Glossary 73
- The Intelligent Use of Water 80
© 2020, manymanuals.com. All rights reserved. | 0.050 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals