AMX RADIA LIGHTING CONTROL ENCLOSURE WORKSHEET GUIDE Specifications download pdf (Page 35)

5. Routine Operations

Rain Bird

ET Manager Series - Installation and Operation Manual 35

Automatic Window Open

The Automatic Window is a period of time pro-

grammed in your ET Manager corresponding to the

time period the sprinkler controller is programmed to

water with ET-based control. When the Automatic

Window “opens,” it looks at the current moisture bal-

ance and Irrigation Amounts and determines if water-

ing is needed for Valve Groups A and/or B. Once the

Automatic Window “opens,” it remains “open” for the

entire period. Watering is either interrupted or enabled

the entire time. Changes to the moisture level during

this period will not affect the “decision” to interrupt or

enable watering. Those changes will affect the next

Automatic Window period.

Daily Window Open

The Daily Window is a period of time programmed in

your ET Manager corresponding to the time period the

sprinkler controller is programmed to water BUT NOT

based on ET control. Watering is allowed every day

during the Daily Window. When the Daily Window

“opens” it enables or allows watering on both Valve

Groups A and B. The Daily Window period operates

outside the Automatic Window.

Disabled Mode

When the ET Manager is disabled all automatic func-

tions are suspended. The ET Manager will not interrupt

the sprinkler controller; it will operate as if the ET

Manager was not there. The normal operating mode is

Automatic.

No Water Day

Available watering days can be programmed in your ET

Manager. If the current day has been set to “Off,”

watering will not be enabled regardless of the current

Moisture Levels. The No Water Day status message

indicates if the current day has been set to “Off.”

Hour Manual Override

Your ET Manager can be temporarily “Overridden” to

allow manual watering. Pressing the Override button

once starts a one-hour override. Each time the

Override is pressed one more hour is added to the

Override mode. The status display indicates when an

Override has been started and the amount of time left

before it reverts back to the normal operating mode.

No Power

The ET Manager needs power to operate. The battery is

used only to keep time during a power outage and keep

the display screen active. If there is no power, a No

Power message will appear. Restore power to your ET

Manager. If power has been off for a week, the battery

should be replaced.

Attention Messages

If the Attention Indicator Light turns yellow there is a

condition that you should be aware of. An Attention

condition indicates that normal functions have been

interrupted. On the Home screen, the second line dis-

plays a message indicating the condition. When more

than one message needs to be displayed, the messages

will alternate every few seconds.

Note: Status messages are also displayed on the same

Home screen line.

The following Attention conditions are displayed when

each condition is detected by your ET Manager:

• Temperature Interrupt

• Wind Interrupt

• 24 Hour Rain Interrupt

• 1 Hour Rain Interrupt

• Provider Interrupt

• No Signal Service

• No Weather Data

• No Paging Signal

• Signal Accuracy

• No Historical ET Data

• Decoder Failure

• No Watering Detected

• Rain Tip Input Failure

• Set Signal Provider Code

• Window Overlaps Off Day

1 ... 34 35 36 ... 80

Comments to this Manuals

No comments

AMX RADIA LIGHTING CONTROL ENCLOSURE WORKSHEET GUIDE Specifications Page 35

Comments to this Manuals