AMX RADIA LIGHTING CONTROL ENCLOSURE WORKSHEET GUIDE Specifications Page 31
- Page / 80
- Table of contents
- TROUBLESHOOTING
- BOOKMARKS
Rated. / 5. Based on customer reviews
5. Routine Operations
Rain Bird
®
ET Manager Series - Installation and Operation Manual 31
• High Today: The day’s highest average wind
speed recorded broadcast since midnight.
• Low Today: The day’s lowest average wind
speed recorded broadcast since midnight.
• Graph: Press
À to view the graph. The
graph displays the recorded average wind
speed over the last two weeks.
Humidity
Main Menu Weather Info Humidity
Humidity values included in the weather signal are
recorded hourly averages. The following detail is dis-
played:
• Current: Hourly average humidity percentage
from the latest recorded broadcast.
• High Today: The day’s highest humidity
recorded broadcast since midnight.
• Low Today: The day’s lowest humidity record-
ed broadcast since midnight.
• Graph: Press
À to view a graph that repre-
sents the recorded humidity over the last two
weeks.
Note: If no weather data has been stored in the ET
Manager, each graph screen will be blank.
Irrigation Status
The most important information regarding the control
of your sprinkler system can be seen in the two
Moisture Level screens located in the Irrigation Status
menu. In the Irrigation Status menu, ET, and rain infor-
mation can also be viewed.
A (or B) Moisture Level
Moisture is depleted from the soil due to evaporation.
Rain and water from the sprinkler system replaces this
water. Your ET Manager uses this information to com-
pute the current moisture level. When the Moisture
Level reaches “0” watering is enabled and the sprinkler
controller is allowed to water. Zero does not mean the
soil is completely dry; zero means that the amount of
water allowed to be depleted has evaporated and it is
time to water.
There are three factors used to compute the Current
Moisture Level:
• ET: Water evaporates and transpires from the
landscape based on current weather condi-
tions.
• Effective Rain: Rain is measured using the
selected rain source. Accepted rainfall is limit-
ed by the Effective Rain settings.
• Irrigation: Watering from your sprinkler sys-
tem.
The formula to calculate the Current Moisture Level is:
Current Moisture Level = Last Moisture Level – ET +
Effective Rain + Irrigation, where:
• Last Moisture Level = Moisture Level from the
prior hour
• ET = ET measurements adjusted by the
Landscape Adjustment percentage
• Effective Rain = Limited due to programmed
Max Hourly Rain and Saturation Allowance
• Irrigation = Irrigation Amount setting once
watering is detected
- ET Manager Series 1
- Table of Contents 2
- 1. Introduction 3
- The Weather Reach Water 4
- Management System 4
- Getting to Know your 5
- Rain Bird ET Manager 5
- LCD Contrast 6
- Attention Indicator Light 6
- Specifications 7
- Resource CD Included with 8
- Getting Ready to use 8
- Your ET Manager 8
- Mounting 10
- Wire Connections 11
- 4” insulation off the ends 12
- Wiring Diagrams 13
- Optional Rain Gauge 13
- 2. Installation 14
- Optional External Antenna 15
- Install Battery 16
- 3. Programming 17
- Weather Region 18
- Rain Source 18
- Elevation 18
- Signal Provider Code 18
- 2. Output Method 19
- Output Method 19
- 3. Site Specific Settings 19
- Irrigation Control 19
- Weather Interrupt 23
- System Options 24
- Programming the Sprinkler 25
- Controller 25
- Cycle Start Times 26
- Station Run Times 26
- 4. System Check 27
- Override 28
- Weather Signal Test 28
- Valve Control Test 29
- Water Window Settings 29
- Initial Moisture Levels 29
- 5. Routine Operation 30
- Irrigation Status 31
- 5. Routine Operations 32
- Information Log 33
- Status Messages 34
- Attention Messages 35
- No Paging Signal 37
- Signal Accuracy 38
- No Historical ET Data 39
- Decoder Failure 39
- No Watering Detected 39
- Rain Tip Input Failure 39
- Set Signal Provider Code 40
- Window Overlaps Off Day 40
- 6. Determining 41
- Programmable Settings 41
- Rain Bird 42
- Landscape Conditions 43
- Plant Type 43
- Soil Type 43
- Root Depth 43
- ET Manager Settings 44
- Water Window 45
- Available Days 46
- Advanced Settings 46
- Effective Rain Settings 46
- ET Manager Scheduler 47
- 7. Troubleshooting 48
- Water Management 49
- Troubleshooting 49
- Group are too dry or too wet 50
- 8. Advanced Output Methods 53
- Wiring “A Then B” 54
- ET & Rain Pulse 55
- Wiring ET and Rain Pulse 56
- Using More than One Sprinkler 59
- 9. Appendices 60
- Precipitation Rate 65
- Station Run Time 65
- Master Valve Control 70
- Pump Control 72
- 10. Glossary 73
- The Intelligent Use of Water 80
© 2020, manymanuals.com. All rights reserved. | 0.048 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals