AMX AXB-PT15 POSITRACK CAMERA CONTROLLER Instruction Manual download pdf (Page 47)

Programming

AXB-PT10/15/30 PosiTrack Camera Controllers

The following table lists preset commands.

Preset Commands

CANCEL PRESET

Immediately stops any

active preset recall in

motion.

Examples:

SEND_COMMAND CAM, "’CANCEL PRESET’"

Clears a preset from

memory.

Syntax:

"’CP<preset>’"

Variables:

preset = 1 - 255

Examples:

SEND_COMMAND CAM, "’CP1’"

Clears Preset 1.

SEND_COMMAND CAM, "’CP100’"

Clears Preset 100.

Recalls a stored

preset.

Optional parameters include ramp time for servomotor positional presets, motor

mode, servomotor speed mode, and inclusion (+ default) or exclusion (-) of iris in

preset.

Syntax:

"’RP<preset>[T<time>][S<speed>][I<- or +>]’"

Variables:

RP - preset = 1 - 255

T - time = 0 -255 (in tenths of a second)

S - speed = 0 - 127

I - iris = "-" to exclude, "+" to include

Examples:

SEND_COMMAND CAM,"’RP1’"

Recalls preset 1. Same as turning on channel 101. If any are in servomotor positional

mode, the current voltages for zoom, focus, and/or iris will be ramped to the preset

voltages at the current speed. If any are in servomotor speed mode, the motor drive

outputs for zoom and/or focus outputs will run at their preset-defined speeds until the

preset positions are reached on the POTs. Regardless of the preset type used, the

pan/tilt drives will run at their current speeds until the proper positions are reached on

their POTs. Channel 101 is turned On.

SEND_COMMAND CAM,"’RP1I-’"

Recalls preset 1. Same as turning on channel 101. If any are in servomotor positional

mode, the current voltages for zoom, and /or focus iris will be ramped to the preset

voltages at the current speed. If any are in speed mode, the motor drive outputs for

zoom and/or focus outputs will run at their preset-defined speeds until the preset

positions are reached on the POTs.

Regardless of the preset type used, the pan/tilt drives will run at their current speeds

until the proper positions are reached on their POTs. Channel 101 is turned on.

The iris signal will be excluded from the preset recall and will not be included in dis-

playing feedback as to whether the preset has been completed.

SEND_COMMAND CAM,"’RP10T100’"

Recalls preset 10. If any are in positional mode, voltage outputs for zoom, focus, and/

or iris will ramp to position in 10 seconds. If any are in speed mode, the motor drive

outputs for zoom and/or focus outputs will run at their preset-defined speeds until the

preset positions are reached on the POTs. Pan/tilt outputs use current speed. Turns

on channel 110 when preset 10 is reached.

1 ... 46 47 48 ... 56

Comments to this Manuals

No comments

AMX AXB-PT15 POSITRACK CAMERA CONTROLLER Instruction Manual Page 47

Comments to this Manuals

Related products and manuals for Bridge cameras AMX AXB-PT15 POSITRACK CAMERA CONTROLLER