AMX AXB-PT15 POSITRACK CAMERA CONTROLLER Instruction Manual download pdf (Page 34)

Programming

AXB-PT10/15/30 PosiTrack Camera Controllers

Configuration Commands (Cont.)

FOCUS

PRESET=SPEED

Sets the FOCUS

voltage output to recall

speed presets.

This is applicable only if the FOCUS SIGNAL=S command is in effect, and the

FOCUS switch is set to the S position (servomotor mode).

Syntax:

SEND_COMMAND CAM,"’FOCUS PRESET=SPEED’"

The command for FOCUS output to servomotor mode or motor mode MUST be

configured to match the switch settings.

FOCUS SIGNAL=M

Sets the FOCUS output

to be a motor output.

This setting corresponds to the M position (motor mode) setting on the FOCUS

switch.

Syntax:

SEND_COMMAND CAM,"’FOCUS SIGNAL=M’"

The command for FOCUS signal must be configured to match the switch set-

tings.

FOCUS SIGNAL=S

Sets the Focus output

to be a servomotor

output.

This setting corresponds to the FOCUS switch in the S position.

Syntax:

SEND_COMMAND CAM,"’FOCUS SIGNAL=S’"

The command for FOCUS signal must be configured to match the switch set-

tings.

Sets the lens’ Focus

mode to positional

(default).

Syntax:

SEND_COMMAND CAM,"’FP’"

This command can be used only for servomotor mode.

It causes a logic high (VREF-A) on Pin 7 of the lens control connector. This puts

a servomotor lens into positional focus mode.

Sets the lens’ Focus

mode to speed.

Syntax:

SEND_COMMAND CAM,"’FS’"

This command can be used only for servomotor mode.

It causes a logic low (0 V) on Pin 7 of the lens control connector. This puts a ser-

vomotor lens into speed focus mode.

GET STATUS

(version 3.00 or

higher)

Displays the current

firmware version (Boot

and Download) on the

terminal along with

additional status

information.

The returned boot version is determined by checking the version in flash mem-

ory.

Syntax:

SEND_COMMAND CAM,"’GET STATUS’"

This command is issued from Terminal Emulator mode. When using a NetLinx

master, the ’MSG ON’ command must first be issued to see the status. Besides

the boot and download versions, it also displays the following information:

• Presets - predifined camera positions

• Channel preset - On or Off.

• Current speed - pan, tilt, zoom, focus, and iris speeds

• Current acceleration - a value between 0-255 on an acceleration curve applied

to the movement of the unit from one position to another.

• Acceleration control - On or Off.

• Mode - settings for the camera (servomotor or motor modes)

• Deviation - numeric value corresponding to how far-off from the center point of

your preset you want the camera to be when it finally stops on that preset.

• Speed Priority - level or channel

1 ... 33 34 35 ... 56

Comments to this Manuals

No comments

AMX AXB-PT15 POSITRACK CAMERA CONTROLLER Instruction Manual Page 34

Comments to this Manuals

Related products and manuals for Bridge cameras AMX AXB-PT15 POSITRACK CAMERA CONTROLLER