AMX AXB-PT15 POSITRACK CAMERA CONTROLLER Instruction Manual download pdf (Page 22)

Installation

AXB-PT10/15/30 PosiTrack Camera Controllers

6. Re-attach the camera mount (with camera/lens) to the cradle support bracket using the two 1/2"

screws.

7. Take the entire camera/mount and cradle assembly and align the lens with the Tilt Hub so that

the vertical-axis intersects the center of the camera’s iris, as shown in FIG. 17.

8. Mark the position of the cradle support bracket on the Tilt Hub (for later attachment).

9. Remove the camera/lens and mount piece from the support bracket by unscrewing the two 1/2"

screws on the underside of the camera mount.

10. Secure the support bracket to the Tilt Hub (at the same position marked for the iris alignment)

on the PosiTrack unit with some or all of the four 1/2" screws and washers.

11. Secure the camera/mount to the support bracket by using the two 1/2" screws.

12. Support the weight of the camera cables with a wire tie attached to the wire tie mount on the

lower corner of the face of the PosiTrack unit (FIG. 13).

FIG. 16 Balancing the camera/lens cradle assembly

FIG. 17 Iris alignment with vertical tilt-axis

cradle

(bottom view)

balancing beam

Marker points

Iris

Vertical tilt-axi

The camera/lens cradle can be mounted on either side of the cradle support bracket.

1 ... 21 22 23 ... 56

No comments

AMX AXB-PT15 POSITRACK CAMERA CONTROLLER Instruction Manual Page 22