AMX AXB-PT15 POSITRACK CAMERA CONTROLLER Instruction Manual download pdf (Page 11)

Pre-Installation

AXB-PT10/15/30 PosiTrack Camera Controllers

Pre-Installation

There are four SPDT slide switches in the lens control section (FIG. 3). Three of the switches

toggle the lens control selection between servomotor or motor mode hardware for control of zoom,

focus, and iris. The fourth selects between ± 6 VDC and ± 12 VDC control for motor mode lens

functions.

Each PosiTrack unit consists of two main Printed Circuit Boards (PCBs):

 PosiTrack Processor PCB (PosiTrack Mother Board) contains the main processor, 2MB

FlashROM, and 2MB SRAM.

 PosiTrack Power Management PCB (PosiTrack Daughter Board) contains power

conditioning circuitry, control outputs/inputs to the pan/tilt drives, and zoom/focus/iris

outputs, and inputs to the lenses.

The following table shows the necessary tools when working on the PosiTracks.

Configuration Settings

Both PosiTrack units contain switches for setting the control mode, lens control voltage, RS-232

baud rate, and AXlink address. Before installing the PosiTrack unit, you must set the DIP switches,

lens control mode switches, and lens control voltage switch.

An SPDT switch is a Single Pole-Double Throw switch. This switch is completed at

both positions. An example is the Volt switch that is active in both the 6 and 12

positions.

Necessary Tools

AXB-PT10/15 AXB-PT30

3/32 HEX KEY Anti-Rotation Pin 5/64 HEX KEY Cover Screws

3/16 HEX KEY Camera Mount Screw 1/16 HEX KEY Bezel and Connector Screws

1/16 HEX KEY Cover Screws and Connector

Bezel

3/32 HEX KEY Camera Mount ADJ. Screws

5/64 HEX KEY Tilt Arm Screws 5/64 HEX KEY Tilt Arm Screws

3/32 HEX KEY Camera Mount ADJ. Screws 3/32 HEX KEY Camera Mount ADJ. Screws

1 ... 10 11 12 ... 56

No comments

AMX AXB-PT15 POSITRACK CAMERA CONTROLLER Instruction Manual Page 11