AMX AXB-PT15 POSITRACK CAMERA CONTROLLER Instruction Manual download pdf (Page 12)

Pre-Installation

AXB-PT10/15/30 PosiTrack Camera Controllers

Setting zoom, focus, and iris switches to servomotor or motor mode

Both PosiTrack units support servomotor (+2.5 to +7.5 VDC operating range) and direct-drive

motor (± 6 VDC or ± 12 VDC operating range) lens control. The table below shows how to set the

switches for servomotor mode (S) or motor mode (M). If you are using a direct-drive lens, refer to

the manufacturer's literature to set the VOLT switch for ± 6 or ± 12 VDC control.

Setting the RS-232 DIP switch (S2)

The RS-232 DIP switch (S2) positions 1 and 2 set the stop and data bits, positions 3 through 5 set

the parity, and positions 6 through 8 set the baud rate. FIG. 4 shows the RS-232 DIP switch.

The PosiTrack units contain one EIA RS-232C standard port for equipment that requires RS-232

control. The following communication protocols are supported:

 300, 600, 1200, 2400, 4800, 9600, 19200, and 38400 baud

 7, 8, or 9 Data bits

 1 or 2 Stop bits

 Even, Odd, and None parity settings

FIG. 3 Lens control section (back panel)

Servomotor and Motor Voltage Switch Settings

Servomotor mode Motor mode (+ 6 VDC) Motor mode (+ 12 VDC)

FIG. 4 RS-232 communications parameters DIP switch (S2) (default setting)

AXlink

LED

RS-232

AXlink

S6 VOLT

S1 ZOOM

S3 FOCUS

S4 IRIS

6 12

S M

RS-232

DIP switch

(S2)

1 2 3 4 5 6 7 8

6 12

S M

VOLT

ZOOM

FOCUS

IRIS

S M

6 12

S M

VOLT

ZOOM

FOCUS

IRIS

S M

6 12

S M

VOLT

ZOOM

FOCUS

IRIS

S M

1 ... 11 12 13 ... 56

Comments to this Manuals

No comments

AMX AXB-PT15 POSITRACK CAMERA CONTROLLER Instruction Manual Page 12

Comments to this Manuals

Related products and manuals for Bridge cameras AMX AXB-PT15 POSITRACK CAMERA CONTROLLER