AMX AXB-PT15 POSITRACK CAMERA CONTROLLER Instruction Manual download pdf (Page 38)

Programming

AXB-PT10/15/30 PosiTrack Camera Controllers

Configuration Commands (Cont.)

ZAP!

Initializes all memory in

the unit.

Syntax:

SEND_COMMAND CAM,"’ZAP!’"

This includes speed settings, deviation settings, configuration settings, and all

presets.

Warning! This command clears all user-defined settings.

ZOOM PRESET=POS

Sets the Zoom voltage

output to recall

positional presets

(default).

Syntax:

SEND_COMMAND CAM,"’ZOOM PRESET=POS’"

This is applicable only if the ZOOM SIGNAL=S command is in effect, and the

ZOOM switch is set to the S position (servomotor mode). The command for

ZOOM output to servomotor mode or motor mode MUST be configured to match

the switch settings.

ZOOM

PRESET=SPEED

Sets the Zoom voltage

output to recall speed

presets.

Syntax:

SEND_COMMAND CAM,"’ZOOM PRESET=SPEED’"

This is applicable only if the ZOOM SIGNAL=S command is in effect, and the

ZOOM switch is set to the S position (servomotor mode). The command for

ZOOM output to servomotor mode or motor mode MUST be configured to match

the switch settings.

ZOOM SIGNAL=S

Sets the Zoom output

to be a servomotor

output.

Syntax:

SEND_COMMAND CAM,"’ZOOM SIGNAL=S’"

This setting corresponds to the S position (servomotor mode) setting on the

ZOOM switch. The command for ZOOM output to servomotor mode or motor

mode MUST be configured to match the switch settings.

ZOOM SIGNAL=M

Sets the Zoom output

to be a motor output.

Syntax:

SEND_COMMAND CAM,"’ZOOM SIGNAL=M’"

This setting corresponds to the M position (motor mode) setting on the ZOOM

switch. The command for ZOOM output to servomotor mode or motor mode

MUST be configured to match the switch settings.

Sets the lens’ Zoom

mode to positional

(default).

Syntax:

SEND_COMMAND CAM,"’ZP’"

This command can be used only for servomotor mode.

This command causes a logic high (VREF-A) on pin 6 of the lens control con-

nector. This puts the servomotor lens into Positional Zoom mode.

Sets the lens’ Zoom

mode to speed.

Syntax:

SEND_COMMAND CAM,"’ZS’"

This command can be used only for servomotor mode.

This command causes a logic low (0 V) on pin 6 of the lens control connector.

This puts the servomotor lens into Speed Zoom mode.

1 ... 37 38 39 ... 56

Comments to this Manuals

No comments

AMX AXB-PT15 POSITRACK CAMERA CONTROLLER Instruction Manual Page 38

Comments to this Manuals

Related products and manuals for Bridge cameras AMX AXB-PT15 POSITRACK CAMERA CONTROLLER