AMX AXB-PT15 POSITRACK CAMERA CONTROLLER Instruction Manual download pdf (Page 35)

Programming

AXB-PT10/15/30 PosiTrack Camera Controllers

Configuration Commands (Cont.)

GET VERSION

(version 3.00 or

higher)

Displays the current

firmware version (Boot

and Download) on the

terminal.

The Boot version sent back is determined by checking the version in flash

memory.

Syntax:

SEND_COMMAND CAM,"’GET VERSION’"

This command is issued from Terminal Emulator mode. When using a NetLinx

master, the ’MSG ON’ command must first be issued to see the status.

HOME

Goes to the location set

previously via the SET

HOME command.

If there is no user-defined HOME position, then the PosiTrack goes to the

mechanical home position.

Syntax:

SEND_COMMAND CAM,"’HOME’"

This differs from the FIND HOME command in that HOME does not involve a

re-calibration of the PosiTrack’s mechanical position.

Sets the lens’ Iris mode

to auto (default).

Syntax:

SEND_COMMAND CAM,"’IA’"

This command causes pin 8 of the lens connector to float open. A Servomotor

lens will internally pull this signal high. In this mode, the iris signal from the Posi-

Track (pin 5) will be ignored. Instead, the camera has full control of the lens iris,

typically used for Auto Iris mode (if the camera supports it).

Sets the lens’ Iris mode

to local.

Syntax:

SEND_COMMAND CAM,"’IL’"

This command applies Ground (0 V) to pin 8 of the lens connector. It allows iris

control from the PosiTrack.

Sets the lens’ Iris mode

to positional (default).

Syntax:

SEND_COMMAND CAM,"’IP’"

This command can be used only for servomotor mode.

This command causes a logic high (VREF-A) on pin 9 of the lens control con-

nector. This puts the servomotor lens into Positional Iris mode.

IRIS PRESET=POS

Sets the Iris voltage

output to recall

positional presets

(default).

This is only applicable if the IRIS SIGNAL=S command is in effect, and the IRIS

switch is set to the S position (servomotor mode).

Syntax:

SEND_COMMAND CAM,"’IRIS PRESET=POS’"

The command for IRIS output to servomotor mode or motor mode MUST be

configured to match the switch settings.

IRIS PRESET=SPEED

Sets the Iris voltage

output to recall speed

presets.

This is applicable only if the IRIS SIGNAL=S command is in effect, and the IRIS

switch is set to the S position (servomotor mode).

Syntax:

SEND_COMMAND CAM,"’IRIS PRESET=SPEED’"

The command for IRIS output to servomotor mode or motor mode MUST be

configured to match the switch settings.

IRIS SIGNAL=M

Sets the Iris output to

be a motor output.

This setting corresponds to the M position (motor mode) setting on the IRIS

switch.

Syntax:

SEND_COMMAND CAM,"’IRIS SIGNAL=M’"

The command for IRIS output to servomotor mode or motor mode MUST be

configured to match the switch settings.

1 ... 34 35 36 ... 56

Comments to this Manuals

No comments

AMX AXB-PT15 POSITRACK CAMERA CONTROLLER Instruction Manual Page 35

Comments to this Manuals

Related products and manuals for Bridge cameras AMX AXB-PT15 POSITRACK CAMERA CONTROLLER