AMX AXB-PT15 POSITRACK CAMERA CONTROLLER Instruction Manual download pdf (Page 26)

Installation

AXB-PT10/15/30 PosiTrack Camera Controllers

Preparing captive wires

You will need a wire stripper and flat-blade screwdriver (approximately 1/8") to prepare and

connect the captive wires.

1. Strip 0.25 inch (6.35 mm) of insulation off all wires.

2. Insert each wire into the appropriate opening on the connector, according to the wiring

diagrams and connector types described in this section.

3. Turn the screws clockwise to secure the wire in the connector. Do not tighten the screws

excessively; doing so may strip the threads and damage the connector.

Using the AXlink connector for data and power

To use the AXlink 4-pin connector for data communication with the Central Controller and power

transfer from the local power supply (PSN), the incoming PWR and GND cable from the local

power supply must be connected to the AXlink cable connector going to the PosiTrack Controller.

FIG. 22 shows how the power cable from the local power supply is used to power the PosiTrack

Controller and the GND cable is connected onto the existing GND cable on the AXlink cable

coming from the Central Controller. Always use a local power supply to power the PosiTrack unit.

1. Unscrew the PWR and GND wires on the terminal end of the PSN’s 2-pin cable.

2. Pair the GND wires from the PSN and the Central Controller AXlink connectors together and

insert them into the clamp position for GND on the PosiTrack unit’s AXlink connector.

3. Tighten the clamp to secure the two GND wires.

4. Place the PWR wire from the PSN into the open clamp position for PWR on the PosiTrack

unit’s AXlink connector.

5. Tighten the clamp to secure the PWR wire.

Never pre-tin wires for compression-type connections.

FIG. 22 AXlink connector and local +12 VDC power supply wiring diagram

PWR (+)

GND (-)

Local +12 VDC power supply

(coming from the PSN power supply)

PWR +

AXP/TX

AXM/RX

GND -

PWR +

AXP/TX

AXM/RX

GND -

To the PosiTrack unit

To the Central Controller

Do not connect the wire from the PWR terminal on the Central Controller to the PWR

terminal on the PosiTrack unit when you connect an external power supply. Make

sure to connect only the AXM, AXP, and GND wires on the PosiTrack unit’s Axlink

connector when using a local power supply.

1 ... 25 26 27 ... 56

Comments to this Manuals

No comments

AMX AXB-PT15 POSITRACK CAMERA CONTROLLER Instruction Manual Page 26

Comments to this Manuals

Related products and manuals for Bridge cameras AMX AXB-PT15 POSITRACK CAMERA CONTROLLER