AMX NetLinx NXB-KNX Instruction Manual download pdf (Page 7)

NXB-KNX KNX Communications Gateway

Overview

The NXB-KNX KNX Communications Gateway (FG2031-01) allows AMX NetLinx Integrated Controllers the ability

to control, integrate and communicate with homes and buildings that utilize the KNX communication protocol.

KNX is the world’s first open, royalty-free, and platform independent standard for home and commercial building

control.

Product Specifications

FIG. 1 NXB-KNX Interface

NXB-KNX Specifications

Front Panel LEDs • Status (green): Blinks to indicate that the unit is communicating with the NetLinx Master. Any

state other than blinking indicates the unit has not completed boot up.

• KNX (green): Solid on indicates power is on and the unit is connected to the KNX bus.

• Output (red): Lights to indicate traffic from the NXB-KNX to the KNX bus.

• Input (yellow): Lights to indicate traffic from the KNX bus to the NXB-KNX.

Rear Panel Connectors: • KNX 2-pin captive-wire connector (optically isolated).

• Ethernet Port - 10/100 Ethernet with PoE. LEDs show communication activity, connection

status, speeds, and mode information:

SPD (speed) - Yellow LED lights On when the connection speed is 100 Mbps and turns Off

when the speed is 10 Mbps.

L/A (link/activity) - Green LED lights On when the Ethernet cables are connected and

terminated correctly, and blinks when receiving Ethernet data packets.

Power Requirements: • PoE powered – no local Power Supply needed

• IEEE 802.3af Compliant

Memory: • 64 Mbytes of RAM

• 256 Mbytes of FLASH

Dimensions (HWD): With feet:

• 1.66" x 5.54" x 4.10"

• 4.216 cm x 14.07 cm x 10.42 cm

Without feet:

• 1.52" x 5.54" x 4.10"

• 3.861 cm x 14.07 cm x 10.42 cm

Weight: 1.45 lbs. (0.65 kg)

(front)

(rear)

1 2 3 4 5 6 7 8 ... 64

No comments

AMX NetLinx NXB-KNX Instruction Manual Page 7