AMX NetLinx NXB-KNX Instruction Manual download pdf (Page 58)

Appendix A: Telnet Commands

NXB-KNX KNX Communications Gateway

Terminal Commands (Cont.)

Command Description

SET JAVA HEAP

Set the amount of memory allocated for the Java pool. This is the current Java memory

heap size as measured in Megabytes.

• Valid values = 5M - 35M

• Recommended default = 32M

Note: This setting does not take effect until the next reboot.

SET ETHERNET MODE

<CMD>

This command sets the current Ethernet configuration settings - auto OR speed =

10 | 100, duplex = full | half.

Example:

set ethernet mode auto

set ethernet mode speed=100 duplex=full

Note: See GET ETHERNET MODE.

SET FTP PORT

Enables/Disables the NXB-KNX’s IP port listened to for FTP connections.

Note: The device must be rebooted to enable new settings.

Example:

>SET FTP PORT

FTP is enabled

Do you want to enable (e) or disable (d) FTP (enter e or d):

FTP enabled, reboot the NXB-KNX for the change to take affect.

SET HTTP PORT

Sets the NXB-KNX’s IP port listened to for HTTP connections.

Note: The device must be rebooted to enable new settings.

Example:

>SET HTTP PORT

Current HTTP port number = 80

Enter new HTTP port number (Usually 80) (0=disable HTTP):

Setting HTTP port number to

New HTTP port number set, reboot the NXB-KNX for the change to take

affect.

SET HTTPS PORT

Sets the NXB-KNX’s IP port listened to for HTTPS connections.

Note: The device must be rebooted to enable new settings.

Example:

>SET HTTPS PORT

Current HTTPS port number = 443

Enter new HTTPS port number (Usually 443) (0=disable HTTPS):

Once you enter a value and press the ENTER key, you get the following message:

Setting HTTPS port number to

New HTTPS port number set, reboot the NXB-KNX for the change to take

affect.

1 ... 57 58 59 60 61 62 63 64

Comments to this Manuals

No comments

AMX NetLinx NXB-KNX Instruction Manual Page 58

Comments to this Manuals

Related products and manuals for Networking AMX NetLinx NXB-KNX