AMX AXD-CP Specifications download pdf (Page 30)

Button Labelling

Novara ControlPads & KeyPads

a. Gently press the bottom of the Key Cap (no clip) onto the pushbutton.

Do not allow the clips on either side to engage.

b. With the bottom of the Key Cap secured, gently press the top of the Key Cap. This action will engage both clips

simultaneously, and the Key Cap will snap into place on the push button.

FIG. 30 Placing a Button Label inside a Key Cap

Clip

Pushbutton on keypad

Key Cap - tilted so that the bottom

of the Cap is placed on the bottom

of the pushbutton first

At this point, do not allow the clips

on the sides of the Key Cap to engage

Press the top of the Key Cap

down to engage both clips at

once, securing the Key Cap

to the pushbutton

Once the clips are engaged,

the Key Cap is secured

to the pushbutton

Verify that the vertical orientation of the Button Label is correct relative to the keypad.

Be careful to follow these procedures closely - the bottom of the Key Cap must be

installed on the pushbutton before the Key Cap clips engage, or there is a risk of the

button being misaligned.

Also note that removing the Key Caps requires additional steps - see the Removing/

Replacing Button Labels section on page 27 for details.

1 ... 29 30 31 ... 70

No comments

AMX AXD-CP Specifications Page 30