AMX AXB-PCCOM AXLINK TO PC COMMUNICATIONS PORT INTERFACE Instruction Manual download pdf (Page 15)

Installation and Wiring

VTM-D15/A 15" MultiMedia Touch Panel Systems

Installation and Wiring

This section covers the steps necessary to setup the individual MultiMedia components and connect

them together. The three areas of focus ar the main component setup, wiring, installation, and

connection.

Setting up the AXB-TPI/3

The AXB-TPI/3 does not come pre-installed with any input modules. The card provided with the

original system package is the TP3-VID Composite/S-Video Input Module. The TPI/3 can be

configured with any combination of 3 input cards (TP3-RGB, TP3-VGA, and/or TP3-VID).

Installing the input modules

1. Discharge the static electricity from your body by touching a grounded metal object.

2. Disconnect any connectors from the AXB-TPI/3.

3. Remove (counter-clockwise) the two-black thumbscrews on the slot cover corresponding to the

location being used for the inserted input module. Any module can be inserted into any slot

number.

4. Gently insert the module into the brackets inside the card slot and slide the input module into

the enclosure until you feel it contact the slot connector, as shown in FIG. 5.

5. Screw in (clockwise) the two thumbscrews to secure the module.

6. Repeat steps 3 through 5 to insert other input modules, if necessary.

Removing input modules

1. Disconnect any power supply connected to the TPI/3.

Always power down the TPI/3 before attempting to remove or install input modules.

Failure to do so could result in damage to the TPI/3 and/or input modules.

FIG. 5 Inserting an input module

Always power down the TPI/3 before attempting to remove or install input modules.

Failure to do so could result in damage to the TPI/3 and/or input modules.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 51 52

No comments

AMX AXB-PCCOM AXLINK TO PC COMMUNICATIONS PORT INTERFACE Instruction Manual Page 15