AMX AXB-PCCOM AXLINK TO PC COMMUNICATIONS PORT INTERFACE Instruction Manual download pdf (Page 31)

Configuration and Setup

VTM-D15/A 15" MultiMedia Touch Panel Systems

4. Type

?PAR again to verify the driver. The touch name should say Elo IntelliTouch.

Setting the Output Resolution

The output resolution for the monitor must be configured then calibrated.

To set the resolution:

1. Verify the connection of the output display monitor to the Monitor Out port at the rear of the

TPI/3.

2. Use the following command in Terminal Emulator mode:

Refer to the Specifications table on page 6 for the horizontal, vertical, and refresh rates available for

the output coming from the TPI/3.

Supported Touch Devices

Touch Device ID

No touch device 00

Microsoft serial mouse 01

2nd Microsoft Serial Mouse

(MX-MM Mobile Mouse

)

Dynapro

touch monitor 10

MicroTouch

touch monitor 11

Elo IntelliTouch

and VTM-D15/A

touch monitors

Elo AccuTouch

touch monitor 13

EZ Screen

touch monitor 15

External touch driver FF

Mouse 12

This sets the TPI/3 touch device to the VTM-D15/A MultiMedia Touch Panel.

PRGM EX. 2

Available Resolutions

Resolution Refresh Rates

640 x 480 (VGA) 60 Hz, 72 Hz, 75 Hz, 85 Hz

800 x 600 (SVGA) 56, Hz, 60 Hz, 72 Hz, 75 Hz

1024 x 768 (XGA) (default) 60 Hz

Resolution <hor>x<vert>:<refresh>

Allows you to set the resolution (horizontal/vertical) and refresh rate of the touch panel.

PRGM EX. 3

Resolution 1024x768:60

This sets the TPI/3 to send a video signal at 1024 x 768 with a refresh rate of 60 Hz.

PRGM EX. 4

If the video is blurry, try a different refresh rate and/or resolution. Check the output

device to verify you are using refresh rates and resolution settings are compatible

with the device.

1 ... 30 31 32 ... 52

Comments to this Manuals

No comments

AMX AXB-PCCOM AXLINK TO PC COMMUNICATIONS PORT INTERFACE Instruction Manual Page 31

Comments to this Manuals

Related products and manuals for Supplementary music equipment AMX AXB-PCCOM AXLINK TO PC COMMUNICATIONS PORT INTERFACE