AMX AXB-PCCOM AXLINK TO PC COMMUNICATIONS PORT INTERFACE Instruction Manual download pdf (Page 35)

Configuration and Setup

VTM-D15/A 15" MultiMedia Touch Panel Systems

4. Verify the connection of the Touch Screen Signal cable from the touch monitor to the Mouse

Port on the rear of the TPI/3.

5. Launch the NetLinx Studio program from the Start > Programs > AMX Control Disc >

NetLinx > NetLinx Studio folder.

6. From the Main menu bar, select Tools > Master Comm. Settings to display the Communication

Setting dialog box.

7. Select NetLinx from the Platform section.

8. Select Network from the COM Port drop-down menu.

9. Specify the IP Address and IP Port (default is 1319 for a Master Port).

10. Click OK to accept the changes and exit from the Communication Setting dialog box.

11. Select Tools > Windows Telnet from the Main menu bar to open a telnet session.

12. Select Connect > Remote Systems and specify the same IP Address as in step 8.

13. From within the telnet session window, type

SHOW DEVICES. This gives you the device

number of the TPI/3. Example would be a TPI/3 with a value of 00130.

14. Use the following command to set the mouse driver:

15. Set the Output resolution of the TPI/3 by entering:

16. Refer to the Available Resolutions table on page 27 for information on resolution and refresh

rates.

17. Calibrate the TPI/3 by entering:

18. Once in the calibration mode, press the middle of the on-panel cross-hairs as they appear. After

the last cross-hair has been depressed and the coordinates points have been set, a dialog

displays the panel coordinate values.

Send_Command, <TPI/3 device number>,"’@MOU <# for touch driver>’"

Example:

Send_Command 130,"’@MOU 12’"

This command allows you to set the mouse driver number (#12 for VTM-D15/A) on the TPI/3 device using

a specific Device ID number (#130). The Supported Touch Devices table on page 27 lists the supported

touch devices and their associated ID’s. When

PRGM EX. 10

Send_Command, <TPI/3 device number>,"’@res <hor>x<ver>:<res>’"

Example:

Send_Command 130,"’@res 1024x768’"

Sets up the panel to display an output resolution of 1024 x 768 at a default screen refresh rate of 60. If

another refresh rate is needed, enter a colon after the vertical value and then enter the refresh rate value.

PRGM EX. 11

Send_Command, <TPI/3 device number>,"’calibrate’"

Example:

Send_Command 130,"’calibrate’"

Sets up the panel to begin the calibration process. Touch the cross-hairs that appear on the panel to

complete the calibration process.

PRGM EX. 12

1 ... 34 35 36 ... 52

Comments to this Manuals

No comments

AMX AXB-PCCOM AXLINK TO PC COMMUNICATIONS PORT INTERFACE Instruction Manual Page 35

Comments to this Manuals

Related products and manuals for Supplementary music equipment AMX AXB-PCCOM AXLINK TO PC COMMUNICATIONS PORT INTERFACE