AMX AXB-PCCOM AXLINK TO PC COMMUNICATIONS PORT INTERFACE Instruction Manual download pdf (Page 25)

Installation and Wiring

VTM-D15/A 15" MultiMedia Touch Panel Systems

4. Connect a standard RS-232 cable to the Program Port on the front of the TPI/3 Touch Panel

Interface to the COM1 or COM2 ports on the back of your computer.

5. Verify that the VTM-D15/A display is switched Off.

6. Provide power by either connecting the 4-pin AXlink cable from the Central Controller to the

AXlink connector port at the rear of the TPI/3 or by using a local PSN6.5 power supply. Use

the local PSN only if the distance from the power source exceeds the wiring lengths for the

TPI/3 as described in the Wiring guidelines section on page 19. The AXB-TPI/3 beeps when

you apply power and again when AXlink communication is detected.

7. Connect the Power Adapter to the female connector on the Power Cord and then connect the

Power Cord to an electrical outlet (FIG. 20).

Your system is now connected and receiving power.

FIG. 19 Attaching the cables from the panel to the rear of the AXB-TPI/3

FIG. 20 Connection of power cord to power cable

VGA Input cable - connects to

Monitor Out port on TPI/3

Touch Screen cable - connects to

Mouse Port on TPI/3

Mouse Port

Monitor Out port

Connect

incoming

video to

TP3-VID

card

1 ... 24 25 26 ... 52

No comments

AMX AXB-PCCOM AXLINK TO PC COMMUNICATIONS PORT INTERFACE Instruction Manual Page 25