AMX AXB-PCCOM AXLINK TO PC COMMUNICATIONS PORT INTERFACE Instruction Manual download pdf (Page 30)

Configuration and Setup

VTM-D15/A 15" MultiMedia Touch Panel Systems

5. In the COM Properties dialog box, select the default Bits per Second rate of 38400 and turn

Flow Control to None.

6. Type

ECHO ON (will not appear) and press ENTER. Although there are no characters

displayed, the window is now active and ready to receive commands.

7. Type

HELLO and press ENTER. This message is used to verify that serial communication has

been established. When a valid connection exists, the device responds with

HOW ARE YOU

DOING.

8. Follow the remaining setup procedures for an Axcess system configuration. The commands

used for AxcessX and HyperTerminal are the same.

Setting up the VTM-D15/A touch device

The touch drivers are already part of the firmware downloaded from SoftROM but you still have to

use terminal emulator to configure the touch device with the desired driver. Refer to the

Programming section of the AXB-TPI/3 Touch Panel Interface 3 instruction manual for more

information on the MOUSE command.

To configure the touch panel with the correct driver:

1. Verify that all devices are correctly attached (including all cables on the panel and power

sources) to the AXB-TPI/3.

2. Enter

?PAR to verify that the TPI/3 characteristics are correct. The return from the TPI/3

includes these characteristics:

3. Use the following command and Device IDs to set the mouse driver:

• Version indicates the TPI/3 firmware version on

the TPI/3.

• Mouse Type displays the mouse driver

assigned for use through the TPI/3.

• Device # identifies the beginning device address

for the attached touch device.

• Cursor enabled displays whether the

cursor is enabled/disabled.

• # Devices identifies the number of devices that

are assigned for use through the touch panel

firmware.

• Brightness displays the brightness value

associated with the monitor. The ability to

adjust the brightness value is not available.

• Output Resolution displays the horizontal,

vertical, and refresh rate for the monitor

connected to the TPI/3.

• Contrast displays the contrast value

associated with the monitor. The ability to

adjust the contrast value is not available.

Do not calibrate the TPI/3 if you are using a Microsoft

compatible mouse or a mobile

mouse. Do not enter the <> when entering the values or commands.

Mouse<# for touch driver>

This command allows you to see the characters on the display as you type them. The following table lists

the supported touch devices and their associated ID’s.

PRGM EX. 1

1 ... 29 30 31 ... 52

Comments to this Manuals

No comments

AMX AXB-PCCOM AXLINK TO PC COMMUNICATIONS PORT INTERFACE Instruction Manual Page 30

Comments to this Manuals

Related products and manuals for Supplementary music equipment AMX AXB-PCCOM AXLINK TO PC COMMUNICATIONS PORT INTERFACE