AMX AXB-PCCOM AXLINK TO PC COMMUNICATIONS PORT INTERFACE Instruction Manual download pdf (Page 21)

Installation and Wiring

VTM-D15/A 15" MultiMedia Touch Panel Systems

5. The VTM-D15/AB panel should now be mounted on the surface/wall using the secured

VTM-WMB bracket as shown in FIG. 15.

Connecting the cables on a VTM-D15/AB surface mount panel

1. Connect the VGA Input, Touch Screen Signal, and Power cables to the VTM-D15/AB touch

panel as shown in FIG. 11.

2. Once the installation of the Wall Mount Bracket (VTM-WMB) and the connection of the

appropriate cables has been finished, follow the steps in the Wiring the AXB-TPI/3 section on

page 18.

FIG. 15 Rear of VTM-D15/AB shown with attached VTM-WMB bracket

FIG. 16 Attaching the cables to the rear of the VTM-D15/AB

Surface Mount bracket (on wall)

Monitor Mount bracket (on panel)

Rear view of panel (as seen from wall)

VGA Input cable - connects from panel

to Monitor Out port on TPI/3

Touch Screen cable - connects

from panel to Mouse Port on TPI/3

12 VDC connector - routes

power from the power cord and

adapter

Power Adapter

12 VDC

input

VTM-WMB

Wall Mount

Bracket

Do not plug in the power cord to the Power Adapter at this time. Power is supplied

after the entire system is wired together. Refer to the Connecting the MultiMedia

Components section on page 20 for powering procedures.

1 ... 20 21 22 ... 52

No comments

AMX AXB-PCCOM AXLINK TO PC COMMUNICATIONS PORT INTERFACE Instruction Manual Page 21