AMX AXB-PCCOM AXLINK TO PC COMMUNICATIONS PORT INTERFACE Instruction Manual download pdf (Page 19)

Installation and Wiring

VTM-D15/A 15" MultiMedia Touch Panel Systems

Connecting the cables on a VTM-D15/A table top panel

1. Connect the VGA Input, Touch Screen Signal, and Power cables to the VTM-D15/A touch

panel as shown in FIG. 11.

2. Once the installation of the Table Top Bracket and the connection of the appropriate cables is

finished, follow the steps in the Wiring the AXB-TPI/3 section on page 18.

Surface Mount Installation (VTM-D15/AB and D15/ASB)

This process involves installing the Wall Mount Bracket (VTM-WMB) and connecting the

appropriate cables to their respective locations. The surface mount is used to mount the panel to any

vertically level surface.

Installing the Surface Mount support bracket

The VTM-WMB Surface Mount Kit consists of four screws, a Surface Mount, and Monitor

Brackets (FIG. 12).

1. Carefully use both hands to close the display stand by pulling back on the Fold switch (FIG. 8).

FIG. 11 Attaching the cables to the rear of the VTM-D15/A

VGA Input cable - connects from panel

to Monitor Out port on TPI/3

Touch Screen cable - connects

from panel to Mouse Port on TPI/3

12 VDC connector - routes

power from the power cord and

adapter

Power Adapter

12 VDC

input

Do not plug in the power cord to the Power Adapter at this time. Power is supplied

after the entire system is wired together. Refer to the Connecting the MultiMedia

Components section on page 20 for powering procedures.

1 ... 18 19 20 ... 52

No comments

AMX AXB-PCCOM AXLINK TO PC COMMUNICATIONS PORT INTERFACE Instruction Manual Page 19