AMX AXB-PCCOM AXLINK TO PC COMMUNICATIONS PORT INTERFACE Instruction Manual download pdf (Page 17)

Installation and Wiring

VTM-D15/A 15" MultiMedia Touch Panel Systems

Table Top Installation (VTM-D15/A and D15/AS)

This process involves installing the support bracket and connecting the appropriate cables to their

respective locations.

Installing the Table Top support bracket

To avoid vibrations when you touch the display, install the Table Top support bracket. After

installation of the bracket, the display tilt angle is approximately 10 degrees from vertical.

1. While on a flat surface, use both hands to gently unfold (pull-down) the display stand by

flipping it downward (FIG. 7).

2. Use the Fold switch (FIG. 8) to lock the angle of the stand.

3. Pull back on the Fold switch again to unlock the support when putting the panel up fo r s to ra ge .

4. To fix the panel into position, hold the base with one hand and use the other to move the panel

into position.

5. Insert the double-raised end of the Table Top Support Bracket (FIG. 9) into the fixing holes

located on the display stand. One support bracket and two screws come with the VTM-D15/A.

There are two fixing holes on each side of the stand.

FIG. 7 Removing the protective cover

FIG. 8 Unfolding and angling the display by using the Fold switch

Fold switch

1 ... 16 17 18 ... 52

No comments

AMX AXB-PCCOM AXLINK TO PC COMMUNICATIONS PORT INTERFACE Instruction Manual Page 17