AMX AXB-PCCOM AXLINK TO PC COMMUNICATIONS PORT INTERFACE Instruction Manual download pdf (Page 33)

Configuration and Setup

VTM-D15/A 15" MultiMedia Touch Panel Systems

Using AXCESSX for AXlink communication

1. Verify the connection of one end of a AXlink cable on the rear of the TPI/3 to the respective

connector location on the Axcess Central Controller.

2. Verify that the AXB-TPI/3 is receiving power through either an external power source or the

AXlink cable connection from the Controller. The AXB-TPI/3 beeps when you apply power

and again when AXlink communication is detected.

3. Verify the connection of the DB-15 video cable from your VTM-D15/A panel to the Monitor

Out port at the rear of the TPI/3.

4. Verify the connection of the Touch Screen Signal cable from the touch monitor to the Mouse

Port on the rear of the TPI/3.

5. Refer to the Using AXCESSX for serial communication section on page 24 for the steps needed

to open and prepare the program for communication.

Using HyperTerminal for AXlink communication

1. Verify the connection of one end of a AXlink cable on the rear of the TPI/3 to the respective

connector location on the Axcess Central Controller.

2. Verify that the AXB-TPI/3 is receiving power through either an external power source or the

AXlink cable connection from the Controller. The AXB-TPI/3 beeps when you apply power

and again when AXlink communication is detected.

3. Verify the connection of the DB-15 video cable from your VTM-D15/A panel to the Monitor

Out port at the rear of the TPI/3.

4. Verify the connection of the Touch Screen Signal cable from the touch monitor to the Mouse

Port on the rear of the TPI/3.

5. Refer to the Using HyperTerminal for serial communication section on page 25 for the steps

needed to open and prepare the program for communication.

Setting up the VTM-D15/A touch device through AXlink

The touch drivers are already part of the firmware downloaded from SoftROM but you still have to

use terminal emulator to configure the touch device with the desired driver. Refer to the

Programming section of the AXB-TPI/3 Touch Panel Interface 3 instruction manual for more

information on the @MOU command.

To configure the touch panel with the correct driver:

1. Verify that all devices are correctly attached (including all cables on the panel and power

sources) to the AXB-TPI/3.

2. Type

ECHO ON (will not appear) and press ENTER. Although there are no characters

displayed, the window is now active and ready to receive commands.

3. Type

SHOW INPUT ON and press ENTER.

4. Type

VER and press ENTER to get the Device ID number for the TPI/3 Touch Panel Interface.

Do not calibrate the TPI/3 if you are using a Microsoft

compatible mouse or a mobile

mouse. Do not enter the <> when entering the values or commands.

1 ... 32 33 34 ... 52

Comments to this Manuals

No comments

AMX AXB-PCCOM AXLINK TO PC COMMUNICATIONS PORT INTERFACE Instruction Manual Page 33

Comments to this Manuals

Related products and manuals for Supplementary music equipment AMX AXB-PCCOM AXLINK TO PC COMMUNICATIONS PORT INTERFACE