AMX NI-2000 Instruction Manual Page 39

  • Download
  • Add to my manuals
  • Print
  • Page
    / 134
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 38
Installation and Upgrading
33
NetLinx Integrated Controllers
6. Insert the upgrade card into the connector opening with the arrow facing towards the pins, then
push it in firmly until the contact pins are completely inside the flash card and securely
attached to the connector (FIG. 21).
7. To complete the upgrade process, close and re-secure the Integrated Controller enclosure using
the procedures outlined in the following section.
Closing and Securing the Integrated Controller
Once the card has been replaced, close and re-secure the outer housing:
1. Align the cover over the unit and gently slide-down the cover until the chassis housing
openings are aligned over their respective openings along both the sides and top of the unit.
2. Begin pushing-down the housing until the cover is securely positioned over circuit board.
3. Insert the chassis housing screws into their respective locations, as shown in FIG. 20.
4. Securely tighten these screws by using a grounded screwdriver turning in a clockwise
direction.
5. Re-install all connectors and apply power.
FIG. 21 Removing the Compact Flash card
Under-side groove
located below
Insert with arrow
facing towards
the connector pins
Card Removal Grooves
Any new internal card upgrade is detected by the Controller only after power is
cycled.
Page view 38
1 ... 38 39 40 ... 134

Comments to this Manuals

No comments