AMX NI-2000 Instruction Manual download pdf (Page 37)

Installation and Upgrading

NetLinx Integrated Controllers

Here's the syntax:

NUMBER:PORT:SYSTEM

where:

Removing NetLinx Control Cards (NI-4000 Only)

To install NetLinx Control Card:

1. Discharge any static electricity from your body, by touching a grounded object and unplug all

connectors (if any) from the unit.

2. Remove the three faceplate screws by turning them in a counter-clockwise direction.

3. Remove the faceplate from the front plate (FIG. 18 on page 29).

4. Gently grasp the rear edge of the control card and gently pull it out from the unit (along the

internal guide slots).

5. Re-secure the faceplate by inserting the three faceplate screws by turning them in a clockwise

direction and securing the front plate to the Integrated Controller.

6. Re-apply power and other connections as necessary.

Compact Flash Upgrades

The NetLinx Integrated Controllers are shipped with a default 32 MB Compact Flash module.

The Compact Flash card is factory programmed with specific Controller firmware. These cards can

be ordered from AMX in several different upgrade sizes (see the following table):

Accessing the internal components on an Integrated Controller

1. CAREFULLY DETACH ALL CONNECTORS from the rear of the unit.

2. Remove the chassis housing screws from both the sides and top of the Controller, as shown in

FIG. 20 by using a grounded screwdriver turning in a counter-clockwise rotation.

The NI-4000 has six screws on top and four on each side. The NI-2000/3000 units have six

screws on top and three on each side.

NUMBER: 16-bit integer represents the device number

PORT: 16-bit integer represents the port number (in the range 1 through the number of

ports on the Controller or device)

SYSTEM: 16-bit integer represents the system number (0 = this system)

It is recommended that ANY MEMORY UPGRADE should be done prior to any

installation. Refer to the following accessing and installation sections for more

information.

Optional Compact Flash Upgrades

Product Name Description

NXA-CFNI64M 64 MB compact flash card (FG2116-31)

NXA-CFNI128M 128 MB compact flash card (FG2116-32)

NXA-CFNI256M 256 MB compact flash card (FG2116-33)

NXA-CFNI512M 512 MB compact flash card (FG2116-34)

NXA-CFNI1G 1 GB compact flash card (FG2116-35)

1 ... 36 37 38 ... 134

No comments

AMX NI-2000 Instruction Manual Page 37