AMX Mio Modero Device Family Technical Information download pdf (Page 24)

Mio Modero IR

Mio Modero Device Family

Mounting Procedure

FIG. 15 shows the wallbox mounting dimensions for the Mio Modero IR. AMX recommends mounting

the Mio Modero IR in a standard one-gang wallbox, a conduit box per NEC specs section 370, with a

minimum internal clearance of 2-5/8" x 1-3/4" x 1-5/8" (HWD).

1. Use the cutout dimension for the wallbox to cutout the install surface for the Mio Modero IR.

2. Confirm that the terminal end of the AxLink cable is disconnected, and not receiving power.

3. If the faceplate is connected to the mounting frame, place a flathead screwdriver in the notch at the

bottom right of the Mio Modero IR, and pry the faceplate from the mounting frame.

4. Connect the AxLink power supply. The connector passes through the center of the mounting frame

and connects to the board.

5. Place the mounting frame on the wallbox; align the screw holes with the mounting holes and fasten

the mounting frame to the wallbox using the screws supplied.

6. Attach the faceplate to the mounting frame first at the top and swing it to the bottom. See FIG. 16.

FIG. 15 Mio Modero IR mounting dimensions

2.250

[57.2 MM]

[83.4 MM]

3.282

[50.8 MM]

2.000

1 ... 23 24 25 ... 34

No comments

AMX Mio Modero Device Family Technical Information Page 24