AMX Mio Modero Device Family Technical Information download pdf (Page 16)

Installation

10

Mio Modero Device Family

Using AxLink for data with an auxiliary power supply

Connect the controller’s AxLink connector to the AxLink connector on the rear panel of the Mio Modero

device, as shown in FIG. 7.

Use an auxiliary 12 VDC power supply when the distance between the controller and server exceeds the

limits described in Wiring Guidelines table. Connect only the GND (-) wire on the AxLink connector

when using an auxiliary 12 VDC power supply.

FIG. 7 AxLink and 12 VDC power supply wiring diagram

PWR (+)

AXP

AXM

GND (-)

PWR (+)

AXP

AXM

GND (-)

Mio Modero device (3.5 mm connector)

Controller

PWR (+)

GND (-)

12 VDC power supply

If you are not using power from AxLink, disconnect the wiring from the controller

before wiring the Mio Modero device. Make sure the auxiliary power supply’s PWR

(+) is not connected to the controller’s AxLink connector.

1 ... 15 16 17 ... 34

Comments to this Manuals

No comments