AMX Mio Modero Device Family Technical Information download pdf (Page 20)

Installation

Mio Modero Device Family

Accent Frame

While the Mio Modero device family does fit into many International wallboxes, it may be necessary to

utilize the optional accent frame to completely cover the wallbox.

To install the Mio Modero with the optional accent frame:

1. Use the cutout dimension for the wallbox to cut out the install surface for the Mio Modero.

2. Place the accent frame on the wallbox; align the screw holes with the mounting holes on the

wallplate. Fasten the wallplate to the wallbox.

Based on the extensive number of international wallboxes it is not pragmatic to ship

every possible screw that could be used. Please use the screws appropriate for your

specific wallbox.

Confirm that the terminal end of the AxLink cable is disconnected, and not receiving power.

4. If the faceplate is connected to the mounting frame place a flathead screwdriver in the notch at the

bottom right of the Mio Modero IR, and pry the faceplate from the mounting frame.

5. Connect the AxLink power supply. The connector passes through the center of the mounting frame

and connects to the board. The connection is illustrated in FIG. 2.

6. Place the mounting frame on the accent frame; align the screw holes with the mounting holes and

fasten the mounting frame to the wallplate. The Accent Frame is shipped with two #6-32 x .187

long flat head screws (80-131); these are used to attach the Mio panel to the accent frames.

7. Snap the faceplate to the mounting frame.

Do not overtighten the screws when mounting the mounting frame. The device

should be flush with mounting surface.

1 ... 19 20 21 ... 34

No comments

AMX Mio Modero Device Family Technical Information Page 20