AMX DESIGN XPRESS V 1.5 - PROGRAMMER GUIDE User's Guide download pdf (Page 105)

KwikNet System Configuration

DAK

PPP Network Definition (continued)

LCP Negotiation Options

Header Compression

Check this box if the PPP network is permitted to negotiate the use of header

compression to reduce the length of the PPP framing header. For most PPP networks,

this box should be checked. If you know that the network's peer does not support header

compression, leave this box unchecked to avoid the unnecessary negotiation.

Magic Number Negotiation

Check this box if magic numbers are to be used during LCP negotiation. Otherwise,

leave this box unchecked. Be sure to leave this box unchecked if you are using a

loopback device driver.

Authentication Options

Require/Accept

KwikNet supports the four authentication protocols listed on this property page. If this

network interface demands that its peer authenticate itself using any of these protocols,

check the box in the column labeled Require. If this network interface will accept a

request from its peer to authenticate this interface using any of these protocols, check the

box in the column labeled Accept.

For each protocol, either Require or Accept or both or neither can be checked. If more

than one protocol is listed as required, the network interface will attempt to authenticate

its peer using each checked protocol in the order listed (EAP to PAP) until successful

with one of the protocols or until all have failed. If more than one protocol is listed as

accepted, the network interface will authenticate itself if, and only if, its peer requests

authentication using one of the checked protocols.

Check the EAP boxes only if this network interface supports the Extensible

Authentication Protocol (EAP).

Check the

MS-CHAP v1 boxes only if this network interface supports the Microsoft

Challenge-Handshake Authentication Protocol (MS-CHAP).

Check the

CHAP boxes only if this network interface supports the standard Challenge-

Handshake Authentication Protocol (CHAP).

Check the

PAP boxes only if this network interface supports the Password Authentication

Protocol (PAP).

Note: If EAP or MS-CHAP support has not been enabled on the PPP/SLIP property

page, then the corresponding PPP authentication options will be ignored.

1 ... 104 105 106 ... 316

No comments

AMX DESIGN XPRESS V 1.5 - PROGRAMMER GUIDE User's Guide Page 105