AMX NetLinx Master-Ethernet Card/Module NXC-ME260 Instruction Manual download pdf (Page 45)

NetLinx Security

NXC-ME260 NetLinx Master-Ethernet Card/Module

Help menu

Type help at the prompt in the Telnet session to display the following help topics:

Help Menu Options

Command Description

----- Help ----- <D:P:S> (Extended diag messages are OFF)

<D:P:S>: Device:Port:System. If omitted, assumes master.

? or Help Displays this list.

DATE Displays the current date.

DEVICE HOLDOFF ON|OFF Sets the master to holdoff devices (i.e. does not allow them to report

ONLINE) until the NetLinx program has completed executing the

DEFINE_START section.

If set to ON, any messages to devices in DEFINE_START will be lost,

however, this prevents incoming messages being lost in the master

upon startup. When DEVICE_HOLDOFF is ON, you must use ONLINE

events to trigger device startup SEND_COMMANDs.

By default, DEVICE HOLDOFF is OFF to maintain compatibility with

Axcess systems where f devices are initialized in DEFINE_START.

DEVICE STATUS <D:P:S> Provides information about the specified device.

DNS LIST <D:P:S> Displays the DNS configuration of a device.

DISK FREE Displays the amount of free space on the disk.

GET DEVICE HOLDOFF Displays the state of the device holdoff setting in the master

GET IP <D:P:S> Displays the IP configuration of a device.

HELP SECURITY Displays security related commands.

IP STATUS Provides information about NetLinx IP Connections.

MEM Shows size of the largest block of available memory.

MSG ON|OFF Enables/Disables extended diagnostic messages.

OFF [D:P:S or NAME,CHAN] Turns off the specified channel.

ON [D:P:S or NAME,CHAN] Turns on the specified channel.

PASS [D:P:S or NAME] Puts the Session in pass mode to the specified device.

• Mode is exited by ++ ESC ESC.

• Display Format is set by ++ ESC n

If n is A, format = ASCII

If n is D, format = Decimal

If n is H, format = Hex

PING [ADDRESS] Pings an address (IP or URL).

Specify -a option for reverse lookup.

PROGRAM INFO Displays a list of program modules loaded.

PULSE [D:P:S or NAME,CHAN] Pulses the specified channel.

REBOOT <D:P:S> Reboots the device.

RELEASE DHCP Releases the current DHCP lease.

ROUTE MODE DIRECT|NORMAL Set the Master-Master route mode.

SEND_COMMAND D:P:S or

NAME,COMMAND

Sends the specified command to the device.The Command uses

NetLinx string syntax.

• Ex: send_command 1:1:1,"'This is a test',13,10"

• Ex: send_command RS232_1,"'This is a test',13,10"

SEND_STRING D:P:S or

NAME,STRING

Sends the specified string to the device.

SET DATE Set the current date.

1 ... 44 45 46 47 48

Comments to this Manuals

No comments

AMX NetLinx Master-Ethernet Card/Module NXC-ME260 Instruction Manual Page 45

Comments to this Manuals

Related products and manuals for Supplementary music equipment AMX NetLinx Master-Ethernet Card/Module NXC-ME260