AMX NetLinx Master-Ethernet Card/Module NXC-ME260 Instruction Manual download pdf (Page 13)

Installation and Wiring

NXC-ME260 NetLinx Master-Ethernet Card/Module

5-Pin Program port (rear panel)

The table below lists the pinouts and signals for the rear panel Program port connector.

ICSNet RJ-45 Connections/Wiring

The following table shows the pinouts, signals, and pairing information to use for ICSNet RJ-45

connections. The ICSNet connections provide power and data to ICSNet devices. Each port

provides up to 500 mA of current.

ICSHub RJ-45 Connections/Wiring

The two ICSHub RJ-45 connectors on the rear of the Master Card provide data to other Hubs

connected to a downstream system. Hubs allow you to connect multiple NetLinx Hubs together in a

daisy-chain configuration. Connect the

OUT port to the IN port on the second or downstream

NetLinx hub.

! Use CAT5 cables for all ICSHub connections.

! Do not connect the last hub in a daisy-chain configuration into the first hub.

5-Pin Program Port Pinouts and Signals

Pin Signal

1GND

2RX

3TX

4CTS

5RTS

ICSNet RJ-45 Pinouts/Signals

Pin Signal Connections Pairing Color

1 TX + 1 --------- 1 1 --------- 2 orange-white

2 TX - 2 --------- 2 orange

3 Mic - 3 --------- 3 3 --------- 6 green-white

4 GND 4 --------- 4 blue

5 12 VDC 5 --------- 5 4 --------- 5 blue-white

6 Mic + 6 --------- 6 green

7 RX + 7 --------- 7 7 --------- 8 brown-white

8 RX - 8 --------- 8 brown

1 ... 12 13 14 ... 48

No comments

AMX NetLinx Master-Ethernet Card/Module NXC-ME260 Instruction Manual Page 13