TELDAT ROUTER - Configuring Frame Relay
II - 19
Doc.DM703-I
Rev.10.00
2. Displaying the Frame Relay configuration prompt
To access the Frame Relay configuration environment, do the following:
1. At the GESTCON prompt (*), type PROCESS 4 (or P 4).
2. At the configuration prompt (Config>), type NETWORK #, # is the name of the interface
over which you want to run Frame Relay.
3. At the Frame Relay interface configuration prompt (FR Config>), use the configuration
commands discussed in this chapter to configure the Frame Relay parameters.
Comments to this Manuals