AMX AVS-OP-0816-567SD Instruction Manual download pdf (Page 42)

Hi-Z Sync Input/Output Boards

Optima SD Instruction Manual

Hi-Z Sync Input/Output Boards

Applicability Notice

This chapter pertains to Hi-Z sync input/output boards (with BNC connectors) contained in the

Optima SD systems in the following table:

Optima SD systems use Hi-Z sync boards to route horizontal and vertical sync signals in conjunction

with the 500 MHz video boards (see page 35). If the system supports audio, the stereo audio board

(see page 39) is located below the Hi-Z sync boards.

Signals may only be routed from the inputs on a board to the outputs on the same board because each

board has its own switching matrix.

Hi-Z Sync Input/Output Boards Specifications

Applies to Hi-Z sync boards contained in the Optima SD systems listed above.

AMX reserves the right to modify its products and their specifications without notice.

Signal(s) Configuration System Sales #

RGBHV 16x16 FGP46-1616-560

RGBHV+Stereo 16x16 FGP46-1616-567

RGBHV 8x16 FGP46-0816-560

RGBHV+Stereo 8x16 FGP46-0816-567

RGBHV 12x12 FGP46-1212-560

RGBHV+Stereo 12x12 FGP46-1212-567

RGBHV 16x8 FGP46-1608-560

RGBHV+Stereo 16x8 FGP46-1608-567

FIG. 21

Hi-Z sync input/output boards (with stereo audio board)

Specifications

Parameter Conditions Value

Input Level (max.) +5.5 V

Input Impedance 22 kohms

Output Level (max.) +5.5 V

Output Impedance 75 ohms

In/Out Polarity Active high or low Output polarity follows input polarity

Output Signal Level Unity gain

Connector Type BNC

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 81 82

No comments

AMX AVS-OP-0816-567SD Instruction Manual Page 42