AMX AVS-OP-0816-567SD Instruction Manual download pdf (Page 25)

Installation & Setup

Optima SD Instruction Manual

Important: Enclosures must be cabled correctly after linking. To ensure that the correct signal

cables are attached to the correct enclosure, check the “AutoPatch Connector Guide” that shipped

with the system, as well as the system / enclosure numbers on the rear of each enclosure.

Link Cable

AMX provides an RJ-45 crossover link cable for direct linking between Optima SD enclosures.

The cable is wired to TIA/EIA-568-A on one end and TIA/EIA-568-B on the other end.

Ethernet Connector LEDs

The ENC LINK port on the CPU has two LEDs that indicate communication status when the enclosure

is linked as part of an active system (FIG. 7).

The LEDs indicate the following:

 Green LED on – speed status is 100 Mbps

 Green LED off – speed status is 10 Mbps

 Amber LED on – link status is active

Note: The Comm (Communication Status) indicator at the top of the CPU board indicates if there is

Ethernet traffic on the system.

FIG. 7 Ethernet connector LEDs

Communication Status indicator

Green LED – Speed Status

Amber LED – Link Status

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 81 82

No comments

AMX AVS-OP-0816-567SD Instruction Manual Page 25