AMX AVS-OP-0816-567SD Instruction Manual download pdf (Page 22)

Installation & Setup

Optima SD Instruction Manual

Rack Installation & System Setup

The Optima SD enclosures can be mounted in a standard EIA 19 in. (48.26 cm) rack. Rack installation

ears are included, and directions for mounting the rack ears are included in the rack installation

instructions (see page 19).

Important: The system requires at least one empty rack unit above and below each enclosure to

allow adequate airflow; three empty rack units are recommended.

Required items for rack installation:

 Enclosures (2)

 Standard EIA 19 in. (48.26 cm) rack

 Rack ears (2 sets with 8 screws per set)

 Screwdriver

 Screws that fit your rack for mounting the enclosures

 Power cords (2)

 Link cable (1)

Optional items for rack installation:

 Surge-protector – highly recommended

 A laptop computer or PC with a null modem cable

(for communication with the Optima SD via its CONTROL / RS-232 port)

Installation Recommendations

The following is a list of installation recommendations:

 Write the system’s serial number in an easily accessible location before installing the

enclosures in a rack. The system’s serial number is located in two places on the enclosures; on

the left rear and on the left side of the enclosures (near the power receptacle).

 Use an earth-grounded power cord / system with the Optima SD.

 Attach all power cords to a single surge protector and/or an AC line conditioner.

 Apply power to the Optima SD enclosures before applying power to the system’s source and

destination devices.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 81 82

No comments

AMX AVS-OP-0816-567SD Instruction Manual Page 22