AMX AVS-OP-0816-567SD Instruction Manual download pdf (Page 35)

Installation & Setup

Optima SD Instruction Manual

Serial Control Device Startup

If you have not already done so, attach the serial control device to an enclosure (see page 22) and open

the control program.

AMX Control Devices

The Optima SD is compatible with a number of AMX control devices. For control programming

information, see the instruction manual for the specific device.

APControl 3.0

If you are using APControl 3.0, install and open the program. Follow the directions in the setup wizard.

From the Launchbar menu, select Views / CrossBar and click on the crosspoints to execute switches.

APWeb

For startup information, see the “APWeb Expansion Board” chapter on page 45.

HyperTerminal

When power is applied to the enclosure, HyperTerminal displays a one-line splash screen followed by

Ready. The system is ready to disconnect the factory default switch and to execute a test switch

(see page 31).

FIG. 17 illustrates an example of the splash screen at power up (your system’s splash screen may differ).

The Optima SD also displays advanced system information when diagnostic BCS commands are

entered; see “Appendix B – Programmer’s Interface for System Diagnostics” on page 63.

For additional information on checking the hardware version, see page 65.

Note: AMX reserves the right to add to the contents of the splash screen at any time, without notice.

FIG. 17 Power-up splash screen in HyperTerminal

[1:Enclosure] AutoPatch Optima v1.4.0

Ready

Hardware version

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 81 82

No comments

AMX AVS-OP-0816-567SD Instruction Manual Page 35