AMX TXC16 Plus Specifications download pdf (Page 73)

SG-2000 MANUAL 66

The SGC Building, 13737 S.E. 26th St. Bellevue, WA. 98005 USA

seconds and if there are no more breaks in the squelch, the unit

will continue in the original direction.

The scan channel mode is similar to the frequency mode in that

when activated, the unit will begin to scan factory

programmed ITU-VOICE and ITU-SITOR channels. The

direction of the scan can be changed using the up and down

arrows. When pressing the arrows in scan, the unit will step

once in that direction and then pause for approximately 2

seconds. This will allow the manual stepping through of the

scan routine to find activity. The ITU or SITOR channels can

be selected by first setting the radio in VOC or TELEX modes

respectively.

The programmed scan mode allows you to program channels

into one of six banks or files for scanning. There are six banks

with up to 10 files in each, allowing up to 60 channels to be

programmed. When scanning, the unit will search through the

selected banks at a pre-determined rate.

This scan rate may be changed at any time using the

SHIFT/FUNC + RATE. keys. If the squelch is on during the

scan routing, scanning will pause on a squelch break. If there

is no further activity on that channel, scanning will resume

after 5 seconds. The up/down arrows can be used to change

the direction of the scan and to step through the scan banks

manually.

13.4 Shift Functions

To access the secondary function keys on the upper half on the front panel, the operator

will depress the SHIFT/FUNC key prior to pressing the desired key. Secondary functions

of keys (The functions printed above the buttons on the panel) are described as follows:

Back Light This function engages the back lighting of the front panel. To

change the back lighting, press “SHIFT FUNCTION,”

“CHANNEL,” then use the up or down arrow to adjust the

back lighting to a comfortable level.

Control Head # This key is used to view the Control Head number pre-

programmed by the manufacturer (see INTCM-XCV key in

preceding section).

View Timer These two keys are used to preview the pre-programmed

alarm times and their corresponding channel or frequency.

SQL Level This function allows you to set a squelch level by using the Up

1 2 ... 68 69 70 71 72 73 74 75 76 77 78 ... 241 242

No comments

AMX TXC16 Plus Specifications Page 73