AMX TXC16 Plus Specifications download pdf (Page 39)

SG-2000 MANUAL 32

The SGC Building, 13737 S.E. 26th St. Bellevue, WA. 98005 USA

19. Re-install control head cable connector (10-position) into rear

panel (from step #5)

20. Re-install cable clamp using one #4 Philips Head screws

(from step #4).

21. Re-install rear panel connector cover using three #4 Philips

Head screws (from step #3).

22. Install louvered top cover (supplied) using six #6 black

Philips Head screws (from step 2).

This concludes the Rack Mount Retrofit Procedure.

9.5 Control Head Installations

The SG-2000 is a multiple control head radio. There are two ways to obtain a remote

head configuration. First is to remove the control head supplied on the SG-2000.

Second is to plug in additional control heads. While most people order their SG-2000

with the Remote Head Kit installed, this item may be installed in the field through the

following procedure:

9.6 Remote Head Kit Installation (Part No. 04-12)

As supplied, the SG-2000 comes with a control panel attached to the front of the radio.

As an option, a remote head kit, part number 04-12 may be installed, extending the

control head 16 feet from the radio and supplying a gimbal mount. Installation takes 10

minutes.

TOOLS REQUIRED: Philips Head Screwdriver

TEST EQUIPMENT REQUIRED: None

CAUTIONS:

• Power must be disconnected from radio for this

procedure.

• Use care not to over tighten screws and strip threads.

Installation Procedure

1. Locate and remove the wiring shield on the back of the SG-2000. This

shield, which runs horizontally across the back of the radio, is held in

place by three Phillips head screws. Unplug the control head number

1 cable.

2. Locate and remove the six black Phillips head screws which secure the

top cover to the SG-2000 and remove the top cover. Two screws are

located on each side of the radio and two screws are located on the top

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 241 242

No comments

AMX TXC16 Plus Specifications Page 39