AMX TXC16 Plus Specifications download pdf (Page 66)

SG-2000 MANUAL 59

The SGC Building, 13737 S.E. 26th St. Bellevue, WA. 98005 USA

INTCM Lower center of display over bar graph. It indicates the

intercom feature to another control head is active. (You can

activate this feature on an SG-2000 with no additional heads

attached, but no one will hear you!)

Bar Graph Lower center of display. Small numbers show under graph

(10, 20, 50, 100). The bar graph displays relative strength of

received signals and relative strength of transmitted signals.

TEMP Lower right corner of display. This light indicates a tem-

perature condition which is abnormal for the transmitter and

means that transmitter power output is being reduced to

correct the condition.

HI LO

PWR Lower left corner of display. This indicates whether the

transmitter is in the high or low power mode. High power

output is 150 watts PEP on SSB and 150 watts CW while low

power is 50 watts PEP and CW output.

Red LED's These two red lights are located in the lower left corner of

the SG-2000 control panel just above the power switch.

The right hand light of this pair indicates that 12 VDC power

is being applied to the radio and that the crystal oven, used

for the onboard frequency standard, is available and is being

supplied.

The left hand light above the power switch indicates that the

radio's electronics are on and ready for operation. Please

always allow for 10 minutes of warm-up for the crystal oven

to insure the frequency standard has stabilized. This is

especially important when the SG-2000 is being operated in

extremely cold environments. The radio will, of course, work

when first turned on with no warm up, but may be slightly

off frequency in violation of regulations which govern

operations.

1 2 ... 61 62 63 64 65 66 67 68 69 70 71 ... 241 242

No comments

AMX TXC16 Plus Specifications Page 66