Amx MIO R-1 AUDIO FG147-04 User Manual download pdf (Page 9)

Programming The MIO R-1 AUDIO

MIO R-1 AUDIO

Programming The MIO R-1 AUDIO

Most functionality of the MIO R-1 AUDIO is handled using the application KeypadBuilder. Go to

www.amx.com for the KeypadBuilder Instruction Manual.

The MIO R-1 AUDIO recognizes a select number of Serial Commands. For a full list and descriptions,

consult Persistent Serial Commands section on page 10.

Using Connector Ports on The MIO R-1 AUDIO

The programming jack is used for communication between the device and KeypadBuilder. The

programming jack uses a three-wire, 2.5 mm stereo jack, you can order the programming cable (FG10-

817) from AMX if you do not currently possess one. While loading your configuration file make sure the

device is situated as such that the batteries will not fall out. The load will fail if your batteries fall out

during the process. The MIO communicates at 115200 baud rate.

To download KeypadBuilder Configuration Files:

1. Set the MIO R-1 AUDIO Download mode to ON. See the Configuration Mode section for details.

2. Flip and turn the MIO R-1 AUDIO AUDIO so that the buttons are facing away from you and the

device is upside down.

3. Holding the device in both hands, place your thumbs on the battery door and push up to slide the

battery door free.

4. Connect the 2.5 mm stereo plug (male) end of the programming cable (FG10-817) into the

programming jack on the bottom side of the remote device.

5. If necessary, connect the DB-9 end of the programming cable to the female DB-9 connector on the

DB-9 extension cable (FG10-727).

6. Connect the female DB-9 terminal end of the extension cable to the port on the back of your

computer.

7. Configure the communication parameters in KeypadBuilder.

FIG. 3 Connecting The MIO to Your PC

Stereo plug

DB-9

Cable FG10-817 to cable FG10-727

Programming jack

MIO R-1 AUDIO Remote

connector

(male)

1 2 3 4 5 6 7 8 9 10 ... 30

No comments

Amx MIO R-1 AUDIO FG147-04 User Manual Page 9