Amx MIO R-1 AUDIO FG147-04 User Manual download pdf (Page 24)

Using the MIO R-1 AUDIO Remote

MIO R-1 AUDIO

Zone Grouping

In this state, zones can be "grouped" together and controlled as a single zone. Press the "GRP" button to enter

"Group Mode".

Adding a Zone To a Group

Press the "GRP" button to enter "Group Mode".

2. Key in zone # to add to group.

3. Press ENTER (to exit Group Mode).

Grouping All Zones

Press the "GRP" button to enter "Group Mode".

2. Key in "99".

3. Press ENTER (to exit Group Mode).

Un-Grouping All Zones

Press the "GRP" button to enter "Group Mode".

2. Key in "00".

3. Press ENTER (to exit Group Mode).

Group Volume Control

Adjusting Volume for the entire Group can be made at any time, as follows:

1. Press the "GRP" button to enter "Group Mode".

2. Volume UP / DOWN as required (NAV Up/Down buttons).

3. Press ENTER (to exit Group Mode).

To bring all zones to the same volume level (after individual zone adjustments have been made), enter Zone

Grouping mode and decrease the volume to 0db, then increase the volume to desired level.

FIG. 8 Group (GRP) button

Group (GRP) button

The zone from which zone grouping is being administered, is assumed to be the 1st

zone in the grouping. It should, therefore, not be added to the grouping.

All zones will have the volume increased/decreased by the adjustment being made.

1 ... 23 24 25 26 27 28 29 30

No comments

Amx MIO R-1 AUDIO FG147-04 User Manual Page 24