Amx MIO R-1 AUDIO FG147-04 User Manual download pdf (Page 17)

MIO Remote Charging Base

MIO R-1 AUDIO

5. Remove the back housing.

6. Place the new housing on the device so that the rechargeable battery port connection is now

accessible. See FIG. 8.

7. Replace the 6 screws.

8. Connect the terminal end of the Lithium-Ion battery to the port shown in FIG. 8. It may be

necessary to use a thin, blunt object to fully seat the battery connector within its port.

9. Press the battery between the rubber pads, with sticker showing, in the housing area of the MIO

remote. Confirm battery is flush with bottom of battery enclosure on bottom housing.

10. Replace the battery door and slide to lock it in place.

11. Begin charging the battery.

Charging The MIO Remote with Charging Base

The MIO remotes receive power for charging from a charging base.

1. Connect the terminal end of the power supply to the bottom external power port on the MIO remote

charging base. See FIG. 6 for location.

2. Route the cable through the provided channel so that it comes out the side of the base.

3. Connect the power cord to an external power source.

4. Place the bottom of the MIO remote into the charging base so the contacts on the device are on top

of the charging contacts inside the charging base. The Power LED on the MIO remote blinks red to

indicate it is charging and illuminates solid red when it is done. Full charge cycle for a depleted

battery is approximately 3 hours.

Avoid placing units equipped with AAA batteries in the charging base.

FIG. 8 Rechargeable Battery Port on The MIO Remote

Lithium Ion Battery

Rechargeable

Battery

Port Connection

1 ... 16 17 18 ... 30

No comments

Amx MIO R-1 AUDIO FG147-04 User Manual Page 17