Amx Mio Modero R-3 User Manual download pdf (Page 8)

Overview

Mio Modero R-3 Remote

Battery Low Indicator

When the battery charge level is too low to sustain continuous operation, the LCD flashes "Battery Low".

If not recharged, the LCD will flash again, and then the device shuts down to prevent a total discharge of the

battery.

To recharge the battery, insert the Mio R-3 into the Mio Remote Charging Base (see the Mio Remote Charging

Base section on page 25).

Installing Custom Buttons

1. Flip and turn the device so that the buttons are facing away from you and the device is upside down.

2. Holding the Mio R-3 in both hands, place your thumbs on the battery door and push up to slide the battery

door free. The battery door will slide in the direction of the bottom end of the device.

3. Unscrew the 6 screw points indicated in FIG. 3.

4. Turn the unit over so that the buttons are facing you.

5. Lift the top assembly away from the PCB.

6. If necessary, push out the standard buttons from the front of the top assembly.

7. Drop on your custom button pad and verify the alignment with the guide posts on the PCB.

8. Place the top assembly back down on the PCB and return the unit over, exposing the 6 screw points.

9. Tighten the 6 screw points.

10. Replace the battery door, and slide the door upwards to lock it in place.

FIG. 3 Internal Mio R-3 Components

6 Screw Points

Programming Jack

1 2 3 4 5 6 7 8 9 ... 32

No comments

Amx Mio Modero R-3 User Manual Page 8